Manual

h.)Pulloutontheblowermotorandrotateit90°sothatthe

exhaustoutletispointingouttheback.Thenrotatethe

blowermotorarounditsexhaustaxis180°sotheflatside

oftheblowermotorispointedup.

NOTE:Thisistheonlywaytheblowermotorwillfit

properlyintheopening.

A. Rotate 90 °

B. Rotate 180 °

C. Flat side of blower motor

i.) Check that the wiring is properly positioned.

j.) Place the power supply cable and grommet through the

center of the outlet hole opening in the mounting panel

and reposition the grommet into its mounting notch.

Non-Vented (recirculating) Installation Through the

Soffit/Cabinet

Measure and mark a round vent opening in the soffit using

the method shown for venting through the wall. Measure and

mark the centerline on the soffit above the range hood area.

A. Vent cover

B. Centerline

Use the vent cover included with the range hood or other vent

cover as a template to outline an opening for the vent. Use a

saber saw or keyhole saw to cut a round opening for the vent

system.

The range hood can be vented inside through the top of the

cabinet.

6W'

(15.9 crn)

A. Grommet/mounting notch

k.) Place the blower mounting panel over the exhaust outlet

and mount it onto the hood housing with the 12 mounting

screws. Tighten the screws.

I.) Pull the blower motor out through the opening in the

blower mounting panel and fasten with the 4 blower

mounting screws.

For non-vented (recirculating) installations, charcoal filters are

necessary. See the "Range Hood Care" section for

instructions on installing charcoal filters.

The Recirculation Kit Part Number 4396565 must be used.

5. Install the vent system according to the method needed. Use

caulking to seal the exterior wall or roof opening.

6. Run the wiring through the wall or cabinet according to the

national Electrical Code and all local codes and ordinances.

Use caulking to seal around wire opening.