Oven User Manual

ManualsBrandsKitchenAid ManualsOvenKGBS 146S

GAS BUILT-IN

SINGLE & DOUBLE OVENS

MODEL (single).

KGBS 146s

MODEL (double).

KGBS 246s

INSTALLATION

INSTRUCTIONS

INSTALLER: FINAL CHECK LIST

PLACEMENT OF UNIT

0 1. Properly positioned - level, aligned and square with cabinet opening.

0 2. Anchored securely to cabinet.

cl 3.0

ven must not be placed under countertop or microwave oven.

ELECTRICAL

0 1. Oven properly grounded,

0 2. Polarized three-wire 12OVAC. 15.20Ampere receptacle with 15-20ampere overcurrent

protection provided for service cord connection.

GAS SUPPLY

0 1. Supply line of 3/8” black iron pipe provided,

0 2. Manual gas shutoff valve must be installed in accessible location. Do Not install shutoff valve

behind oven.

0 3. Oven connections must be tested for gas leaks.

OPERATIONAL

[7 1. If used on LP gas, verify that pressure regulator and orifice hoods have been modified for

use with LP gas.

0 2. Oven racks installed and

slide freely in all posttions.

0 3. Knobs secured in place and rotate freely without rubbing on edge of control panel glass

holes,

0 4. Selector switch functions in all modes.

0 5. All lights function properly.

0 6. Refer to use and care guide to set electronic clock.

0 7. Doors properly adjusted, open and close smoothly.

0 8. Unless instructed to leave for owner, remove all tags, labels and internal packing material.

0 9. Oven has been wiped clean to remove fingerprints and other smudges.

THANK YOU INSTALLER:

1. Complete Installation Check List.

Leave all literature for customer.

Notify dealer that installation is completed.

FOR DETAILED INSTRUCTIONS, FOLLOW METHODS DESCRIBED IN THIS FOLDER.

Summary of content (11 pages)

PAGE 1
m GAS BUILT-IN SINGLE & DOUBLE OVENS MODEL (single). KGBS 146s MODEL (double). KGBS 246s INSTALLATION INSTRUCTIONS INSTALLER: PLACEMENT OF UNIT 0 1. Properly positioned 0 2. Anchored cl 3.0 - level, aligned and square with cabinet opening. ven must not be placed under countertop 2. Polarized protection CHECK LIST securely to cabinet. ELECTRICAL 0 1. Oven properly 0 FINAL or microwave oven. grounded, three-wire provided 12OVAC. 15.20Ampere receptacle for service cord connection.
PAGE 2
IMPORTANT: assure proper Read Before Installing performance, and INSTALLATION owner’s to Save Time, warranty Work, protection. INSTRUCTIONS The oven installation must conform with local codes and ordinances and ulility regulations. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1-latest edition.
PAGE 3
- 24‘ to inside of back cabinet 2-l/2” MIN to upper cab. doors - 24” MIN _ 24to Inside of cabinet back 2-112” MIN to upper cab. doors _ I I I - 22-112’MIN 24- MIN - - - 22-112’ MIN i I l/2- to lower cab. doors MIN , t ------- 9’ MIN Floor . 1 DOUiiLE OVENS KGBS 246s SINGLE OVENS KGBS 146s ELECTRICAL Electrical Shock Hazard Electrical ground is required on this appliance. . Improper connection of the equipment- grounding conductor line can result in electrical shock.
PAGE 4
UNPACKING THE UNIT Personal Injury More than one person is required to lift or move the oven because of its weight and size. Failure to follow these instructions may result in personal injury. Floor Damage Keep shipping base under oven. Failure to do so could cause damage to floor covering. The oven should be left on the carton base until it is ready to put into the cabinet. It is also recommended that the pad(s) over the door(s) be left in place.
PAGE 5
INSTALLING THE UNIT IN CABINET Route electric supply cord so that it can be plugged into receptacle after unit has been slid into place in cabinet. Potential Personal Injury Use both hands to remove oven doors. Grasp only the sides of the oven door. Do Not use any portion of the front frames or trim for lifting. Failure to properly grasp oven door could result in damage to product or personal injury.
PAGE 6
CHECKOUT AND After the oven is installed tricity is off before turning on ALL gas connections. ADJUSTMENT and the gas connected, all gas connections MUST be tested for gas leaks. Be sure that elecon the gas supply. Test with pressure gauge or apply soapy solution or leak detector solution Repair any leaks that may appear before operating oven. THE REGULATOR IS SET FOR USE WITH NATURAL GAS. FOR USE WITH LP GAS, THE REGULATOR MUST BE CONVERTED.
PAGE 7
The appliance and during any pressure Its individual shutoff testing of that system valve must be disconnected from the gas supply at test pressures in excess of % psig. The appliance must be isolated from the gas supply valve during any pressure testing of the gas supply psig. This gas. unit may be used on natural or LP gas.
PAGE 8
SCHEMATIC DIAGRAM KGBS14BSBLO KGBS24BSBLO El = c”u”yu; > INCI ELECTRONIC CLOCK = OVEN LIGHT SWITCH U.O. LIGHT - L.O. LIGHT ROTISSERIE MOTOR U.O. IND.
PAGE 9
POWER IN).
PAGE 10
POWER IN). u-0. IN).
PAGE 11
Part No. 3177319 Rev C (C) 1989 KitchenAid, Inc. Prepared by KitchenAid, .ll St. Joseph, Michigan 49085 Printed in U.S.