Installation guide

ManualsBrandsKitchenAid ManualsRangeOfficial KitchenAid electric freestanding range

HOME APPLIANCES g75s647

11 " I "

Tip Over Hazard

A chld or adult can tip the range and

be kl[ed.

Connect anthtip bracket to rear

range foot.

Reconnect the anti-tip bracket, if the

range is moved.

Failure to follow these instructions can

result in death or serious burns to

children and adu[ts.

iiiii_!:_i_}I iiiiiiiiiiii

i_i i i i

iiiiiiiiiiiiiiiii

Quick Reference

Table of Contents:

Pages

[]

%-%

[]

Before you start

Product dimensions

Cabinet dimensions/requirements

Electrical requirements

installation steps

Check operation

if range does not operate

if you need assbtance/service

Moving the range

wwwJ<itchenai&com

Read and save these instructions.

iMPORTANT:

[nstaler: Leave Installation

Instructions with the homeowner.

Homeowner: Keep installation

instructions for future reference,

Read and save these instructions

for local electrical inspector's use.

Write down the model and serial

numbers before installing range.

Both numbers are listed on the

model/serial rating plate located

on the oven frame behind the

storage drawer panel,

Model #

Serial # Part No. 9758647

Summary of content (12 pages)

PAGE 1
® HOME APPLIANCES 11 " I g75s647 " e Quick Reference Table of Contents: Pages Tip Over A chld or adult be kl[ed. Connect anthtip range foot. Hazard can tip the range bracket Reconnect the anti-tip range is moved. and to rear bracket, if the Failure to follow these instructions result in death or serious burns to children and adu[ts.
PAGE 2
Mobile Before you start... Your safety and the safety others are very important. of We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word 'DANGER" or 'WARNING.
PAGE 3
Product dimensions _--- 46-13/16" (119.0 cm) overall height 26-5/8" (616cm) depth with handle 36" cooktop (91.4 cm J When installed in a 24" (61.0 crn} base cabinet with 25" (63.5 crn) countertop, front of oven door protrudes 1-7/8" (4.8 cm) beyond 24" (61.0 crn) base cabinet. 30" (76.2 cm} _width J Cabinet dimensions/requirements Cabinet opening dimensions shown are for: 25" (63.5 crn) countertop depth, 24" (61.0 crn) base cabinet depth, 36" (91.
PAGE 4
Electrical requirements if codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path and wire gauge are in accordance with local codes. This range must grounded metal, system. [_ The range can be connected directly to the fused disconnect (or circuit breaker box) through flexible armored be connected to a permanent wiring Allow two to three feet Check with a qualified electrician if you are not sure range is properly grounded.
PAGE 5
New start... EJectricaJ Excessive Weight Use two or more install range. people Hazard to move Failure to do so can result other injury. located and in back m Remove shipping materiab, tape and protective film from range. Keep cardboard bottom and shipping base under range+ Remove oven racks and parts package from inside oven. A child or adult be killed. Connect anti+tip range foot. Hazard can tip the bracket range and ++--I to rear block cover Reconnect the anti+tip range is moved.
PAGE 6
Power suppJy cord method: NOTE: The bag containing three aluminum terminal lugs is not used when connecting the range using a power supply cord. 5_ Use either ring-type terminals spade terminals with upturned to connect the power supply. or ends 6_ Complete electrical connection according to your type electrical supply ("Four-wire electrical connection" or "Three-wire electrical terminal connection[') Four-wire electricaJ 10.
PAGE 7
Direct wire method: Copper or AJurninum 7. NOTE:The bag containing three aiuminum terminai Hugs must be used when making a direct wire connection. 8. IMPORTANT: wire the aluminum terminal lugs must be assembled terminal posts with the facing out as showm to the set screws Attach three aluminum to terminal posts. terminal lugs Use a 3/8" nut driver and tighten the nuts securely, Nuts must be tightened to 20 in/Ibs of torque for proper electrical connection. 9.
PAGE 8
Operating position Move chose to cabinet range m Make Remove cardboard • Look for the anti-tip attached to floor. or hardboard from under range. Carefully move range into final position. I sure the anti-tip bracket bracket securely is installed: opening. M Pull drawer open to first • Slide range back so rear is under anti-tip bracket. range Place rack in oven. Place level on rack, first side to side; then front to back foot stop position.
PAGE 9
Check operation 7[] Check the operation of the cooktop eHements: Push in and turn each surface unit controH knob to "HH" position. Check the operation of the cooktop eHements and indicator Hights. OFF [] Check the operation of the oveR: Press the "CLOCK SET" button. "TIME, HR AND MHN" wHHHight up in the dispHa¥. "0:00" wHHappear and the ":" wHH be flashing. Press the number buttons for the correct time of day. Press "START/ENTER" button to start the chock.
PAGE 10
/f range does not /f you need assistance: If you need service: operate: if you have questions cleaning or maintaining in the event that your KitchenAid appliance should need service, call the deabr from whom you purchased the appliance or a KitchenAid-authodzed service company.
PAGE 11
Notes 11
PAGE 12
i :che HOME APPLIANCES Part No. 9758647 © 2004 KitchenAid ® RegisteredTrademar!< of IqtchenAid. Printed in U.S.A.