Operation Manual

8
Maintenance
- use safety gloves.
- disconnect the appliance from the mains power supply.
GREASE FILTERS
Captures grease particles released by the cooking process.
The grease filter should be cleaned once a month, either by hand or
in a dishwasher at a low temperature and on a short cycle.
Cleaning in a dishwasher may cause the metal grease filter to
become cloudy, but this dos not affect its filtering efficiency
efficiency.
To access the filter for cleaning:
- Remove the hood extraction panel, pulling it firmly downwards with both hands so that it is released
from the fixing pins. The panel will be supported by 4 safety sliders.
- Unfasten the handle to remove the filter.
- Wash the filter and leave it to dry, proceeding in reverse order to refit.
IMPORTANT: Do not wash at temperatures over 65°C.
IMPORTANT: The manufacturer assumes no responsibility for any alterations in colour due to the use of
aggressive detergents.
REPLACING LAMPS
The hood is equipped with a lighting system based on LED technology.
The LEDs guarantee an optimum lighting, a duration up to 10 times as long as the traditional lamps and
allow to save 90% electrical energy.
For replacement, contact the technical service.
WARNING:
Material supplied
Take all parts out of their packaging and make sure all the listed components are included.
• Hood assembled with motor, metal filters and lamps installed.
• Remote control
• Assembly template
• 4 Plugs 10 X 60 mm
• 4 Screws 6 X 70 mm
• 4 Screws 4 X 7 mm
• 2 Screws 3 X 9 mm
• 1 connection flange Ø150 mm