Owner's Manual

7
Issue Code
Shown
(7 Seg
Display)
(if present)
Code Shown
on Front Panel
LED *
(# blinks,
Pause, #
blinks)
What will happen? What to do?
Dishwasher
overfills
F8E4 8 Pause 4
Pause - pause,
repeat
Drain sequence will
begin, machine
operation will be
prevented.
For Professional Installers
Turn off water to unit (if possible). Turn off power to
unit. If the water cannot be turned off, DO NOT turn
off power and keep door closed. Press Cancel key
one time to silence alarm tone. Call service.
For Self Installers
� Press CANCEL button twice or cycle power. This
may clear the issue.
� Check to see if the wire connector is connected to
the float switch on the drip tray. If the wire is off,
reconnect and then hit the cancel button twice.
� Check to see if there is any water in the drip tray. If
water is in the drip tray, remove the water and
reinstall the drip tray. Make sure to connect the
wiring to the float. Check to see where water may
have leaked into the drip tray (Check the water
inlet fittings to see if they are leaking).
� If water was in the tray and no leaks were found,
run the product on the shortest installation cycle
while checking for leaks. The access panel should
be off to observe any leaks.
� If problem still exists, call for service.
Fill valve stuck
on
F8E5 8 Pause 5
Pause - pause,
repeat
Drain sequence will
begin, machine
operation will be
prevented.
Turn off water to unit (if possible).Turn off power to
unit. If the water cannot be turned off, DO NOT turn
off power and keep door closed. Press Cancel key
one time to silence alarm tone. Call service.
Dishwasher will
not drain
F9E1 9 Pause 1
Pause - pause,
repeat
Cycle ends. If drain hose is connected to a garbage disposal,
confirm that drain hose is not clogged and disposal
plug has been knocked out. If unit still will not drain,
call service.
Variable Speed
Drain Motor Fault
- Locked Rotor or
Not Primed
F9E3 9 Pause, 3
Pause - pause,
repeat
Cycle ends. Call service.