Owner's Manual

26
Option A: Waste disposer – no air gap
A
B
C
D
A. Disposer inlet
B. Drain trap
C. Drain hose
D. Drain hose clamp (black
color)
Helpful Tip: Remove disposer knockout plug.
1. Fit rubber end (A) of drain hose to waste tee and cut if
needed.
A
A. Two cut lines
NOTE: Do not cut ribbed section.
2. Using a hammer and screwdriver, knock plug into disposer.
3. Use needle-nose pliers to remove plug.
4. Attach drain hose to disposer inlet with drain hose clamp
(black color) (provided). Use pliers to squeeze clamp open
and move into position.
Option B: No waste disposer – no air gap
A
C
D
B
A. Waste tee
B. Drain trap
C. Drain hose
D. Drain hose clamp (black
color)
1. Fit rubber end (A) of drain hose to waste tee and cut if
needed.
A
A. Two cut lines
NOTE: Do not cut ribbed section.
2. Attach rubber end of drain hose to waste tee with a drain hose
clamp (black color) (provided). Use pliers to squeeze clamp
open and move into position. If the drain hose was cut, use a
1
1
/
2
" to 2" (38 mm to 50 mm) screw-type clamp (not provided).