Owner's Manual

19
15. Consider the material choice of the custom panel and attach
the 1st of the 4 included door panel screws using a Phillips
screwdriver. Check to ensure the door panel is still aligned.
Repeat the screw installation for the 2
nd
hole.
B
A
C
A. 4 x 38 mm Phillips head screw (4)
B. #2 Phillips screwdriver
C. Custom panel
16. Check to ensure the door panel is still aligned.
17. Repeat the screw installation for the last 2 screws.
18. If desired, remove the screws and the panel to remove the
temporary double sided tape.
19. If the door to cabinet gaps are not even, make an adjustment
to the dishwasher by loosening all 4 screws mounted to the
adjacent cabinets. Make the position adjustment.
20. Retighten all 4 screws mounted to the adjacent cabinets. All
screws need to be tight to prevent the dishwasher from
moving.
Electrical Connection
If house wiring does not reach into the adjacent cabinet to the
dishwasher junction box mounting location, the house wiring will
first need to be corrected by a qualified electrician in conformance
with the National Electrical Code, ANSI/NFPA 70 - latest edition,
and all local codes and ordinances.
WARNING
Fire Hazard
Use only the junction box supplied with the product
when making electrical connections.
Do not bypass the junction box.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Electrical Shock Hazard
Electrically ground appliance.
Connect wires together inside the junction box using the
supplied wire nuts.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Direct Wire Connection
1. Route the junction box cable from the dishwasher through the
electrical conduit hole in the cabinet wall. Also route the home
wiring through the same hole as shown below.
A
D
B
C
A. Junction box cable
B. Junction box
C. Cable fittings (2)
D. Home wiring