Owner's Manual

15
9. Toe panel
After removing the access panel remove the toe panel.
10. Measure cabinet opening
There is a leveling system on the front of the base carrier.
Once the dishwasher is within the cabinet space, use the
leveling adjuster to adjust the dishwasher up to the height of
the cabinet.
Adjust both front and back leveling legs to the same height.
Connect Water Line to Fill Valve
The dishwasher may come with the inlet hose already attached
with a threaded connection. It needs to be connected to the inlet
end on the house connection.
11. Leak Detection System Hose (on some
models)
Use the Leak Detection System hose with included 3/8"
(9.5 mm) to 3/4" (19 mm) water inlet adapter.
12. Add 3/8" (9.5 mm) to 3/4" (19 mm) water inlet
adapter to the Leak Detection System Hose
(on some models)
Connect the 3/8" (9.5 mm) compression fitting of the water
inlet adapter to the water supply line and attach the 3/4"
(19 mm) connection to the Leak Detection System hose .
13. Accessory inlet hose
See the “Tools and Parts” section at the front of the guide for
part details and order. Connect the 3/8" (9.5 mm)
compression fitting to the water supply line and Attach the
3/4" (19 mm) elbow fitting connection to the dishwasher
facing upward as shown above. Confirm the flexible braided
or non braided line is long enough to reach the house water
connection. If the hose is not long enough, have a plumber
install a supply valve closer to the dishwasher.
If a Drain Hose Extension is
Required
14. Slide clamp onto connector
A
B
C
D
E
A. Silver clamp
B. Rubber drain hose
connector
C. Stop
D. Drain hose stop
E. Drain hose
Using pliers, squeeze open the silver drain hose clamp, and
slide it onto the connector between stops.