Installation Guide

24
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
1. Turn the manual shut-off valve to the closed position.
2. Unplug range or disconnect power.
A
B
A. To range
B. Shut-off valve (closed position)
C. Gas supply line
Complete Installation
1. Refer to the “Make Gas Connection” section for properly
connecting the range to the gas supply.
2. Refer to the “Electronic Ignition System” section for proper
burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the “LO” setting for
each cooktop burner.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
¼" (0.64 cm) to ½" (1.3 cm) long. The outer cone is not as
distinct as the inner cone. LP gas flames have a slightly
yellow tip.
3. Refer to “Complete Installation” in the “Installation
Instructions” section of this manual to complete this
procedure.
Natural Gas Conversion
To Convert Grill Burner (on some models)
1. Remove grill grate, wave plate, flame spreader, and burner
assembly. See “Install Grill Grease Trays” section for
removal instructions. Set parts aside.
2. Use a ½" deep-well socket to remove the Natural gas
orifice hood. Replace with correct grill LP gas orifice hood.
See “LP Gas Orifice Spud/Hood Chart.”
3. Turn LP gas orifice hood down tightly onto orifice base.
4. Place Natural gas orifice hoods in plastic parts bag for
future use and keep with package containing literature.
5. Before replacing the burner assembly, loosen the screw
at the front of the burner and rotate the shutter so that
the opening is B\zn" (8.0 mm) wide.
6. Reinstall the burner assembly, flame spreader, wave plate,
and grill grate. See “Install Grill Grease Trays” section for
installation instructions.
7. Open shut-off valve in the gas supply line. The valve is open
when the handle is parallel to the gas pipe.
REMEMBER: Once you have completed converting the
grill, test the range for leaks by brushing on an approved
non-corrosive leak-detection solution. Bubbles will show,
indicating a leak. Correct any leaks found.
8. Plug in range or reconnect power.
A
A. Grill orifice hood location
A
B
A. Shutter opening
B. Screw