Installation Instruction

16
A
B
A. Quick-connect elbow adapter fitting
B. Quick-connect stem adapter fitting
C
B
A
A. ¼" water supply tubing
B. O-ring
C. Backstop
Mounting ring and screw
1½" (3.8 cm) clearance
If you need to release tubing:
Push in collet to release tubing. With collet held in, pull tubing
straight out.
Connect to Water Filter Outlet (blue)
1. Attach the supplied ³⁄8" to ¹⁄4" stem or ³⁄8" to ¹⁄4" elbow
quick-connect adapter fitting to the blue water filter
outlet connection by pushing the quick-connect fitting
past the O-ring until you hit the backstop.
2. Connect another piece of flexible codes-approved water
supply line to the quick-connect adapter fitting you just
installed on the filter outlet (blue) side of the water filter.
3. Pull tube to ensure it is secured.
4. Route flexible codes-approved water supply line
through under-sink cabinet and oven cabinet cutout.
A
A. Collet
Water
supply
connection
Shutoff
valve
Water supply tubing
to cold water supply
Yellow
WATER
IN
Water supply tubing to range
Blue
WATER
OUT
Filter
Sink
3. Attach filter to the mounting ring.
Connect to Home Water Supply
1. Make connection to the cold water supply line.
■ A leak-tight connection to the ¼" flexible codes-
approved water supply line must be provided.
■ Check local codes for type of connection required.
■ Flexible codes-approved water supply line must be
cut with a tubing cutter so the ends are concentric and
without burrs.
NOTE: It is recommended that the cold water line be soft water.
Connect to Water Filter Inlet (yellow)
NOTE: Use the quick-connect stem and/or elbow adapter
fittings in the combination needed for your installation
configuration.
1. Attach the supplied ³⁄8" to ¹⁄4" stem or ³⁄8" to ¹⁄4" elbow
quick-connect adapter fitting to the yellow water filter
inlet connection by pushing the quick-connect fitting
past the O-ring until you hit the backstop.
2. Connect the flexible codes-approved water supply line
(not provided) from the home cold water supply pipe to
the quick-connect adapter fitting you just installed on
the filter inlet (yellow) side of the water filter.
3. Pull tube to ensure it is secured.