KDFX 6060 Product sheet
Brief instructions/ Overview 4 Quick Reference Guide 5 How to use the appliance 8 Precautions and general recommendations 13 What to do if...
Brief instructions/ Overview Before using the dishwasher, read the installation and maintenance instructions carefully. Time and malfunction display In normal operation it indicates the remaining time (h:mm), whereas with “Delayed start” selected it indicates the time remaining until the programme starts (e. g. h 01). When using a sensor programme, a dotted line indicates that the calibration process is underway (lasting up to 20 minutes). If "F.. / E..
Quick Reference Guide Table 1.1 Detergent dispenser Programme Chart P Programmes 1 Sensor 2 Pre-Rinse 3 Selectable extra function Consumption 1) Loading instructions large small Litres Automatic programme recommended for routine washes, with dried-on food (for example for EN 50242). X X 7-14 cold Crockery to be washed later. - - 4,0 0,03 14 ± 1) Glass 40°C Light soiling, for example glasses and cups.
Quick Reference Guide Detailed instructions are given on the following pages; also see section "5. What to do if...". 1. Switch the appliance on The dishwasher switches on automatically when any button is pressed, except for the button button is pressed within 30 seconds, the appliance switches to Energy Saving mode. 2. Select the right type of detergent 4 3. Fill the detergent dispenser 4. Check the rinse aid level 5. Set the water hardness level 10 6. Check the salt level 7.
8. Select a programme, and start 5 9. Turn on the water tap, close the door Wash cycle Fill dishes: beware of hot steam! The Start indicator blinks, press the Start button again, the programme resumes from where it had stopped (as happens after a power shortage as well). Change the programme in progress: - Press the Cancel/Off button. - Close the door. - (Water drains for up to 60 seconds). - Open the door. - Select a new programme. - Press the START button. 10. End of programme 11. Open the door 12.
How to use the appliance HOW TO FILL THE DETERGENT DISPENSER Only fill the detergent dispenser prior to starting a wash programme. Only use detergents specially recommended for dishwashers, observing the manufacturer's recommended dosage. Observe the manufacturer's safety warnings! Press the left button (button 1) on the dispenser to open the detergent dispenser compartments. a. Powder/gel/tabs - Fill the detergent dispenser compartments in accordance with the wash programme selected (table 1.1).
Only use rinse aids recommended for use in domestic dishwashers. If rinse aid is accidentally spilt, immediately remove it to avoid the formation of excessive suds which could cause appliance malfunctioning. c. How to adjust the rinse aid dosage regulator: - The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). - Press the button 2 to open the cover.
c. How to set the water hardness level - Press and hold the programme selection button and the Cancel/Off button for at least three seconds. - The hardness level set is shown on the display or the LEDs for programmes 1 - 3 indicate the water hardness setting according to the table below. - With each successive touch of the programme selection button, the setting increases and when it reaches 7 it returns to 1 again.
HOW TO LOAD THE RACKS CUTLERY RACK: May be used in two different positions. In position 2 the upper rack must be lowered (see "Upper rack height adjustment" C below). Position 1 Position 2 For optimum washing results, position cutlery as shown (handles of spoons facing inwards). Beware of sharp/pointed items. Risk of injury! Cutlery holder A May be removed individually, depending on upper rack load.
SELECT PROGRAMME Press the programme selection button until the required programme appears (Table 1.1, Page 5). The appliance will switch on automatically. If required, select options (if supplied). These are saved at the end of the cycle even if another programme is selected. The corresponding indicator lamp lights up. WASH CYCLE The dishwasher door must be closed and the water tap open.
Precautions and general recommendations 1. Packing • The packaging materials are 100% recyclable and marked with the recycling symbol . 2. Removing the packaging and inspecting the contents • After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. 3. Before using the dishwasher for the first time • The appliance is designed to operate at ambient temperatures of between 5°C and 45°C.
What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance... Possible causes/solutions ...is not working/will not start - ... shows "F6 / E2" on the display or the Cancel/Off light flashes alternately 6 times / 2 times - The water tap must be open.
Crockery ... Possible causes/solutions ...are not perfectly clean/have food residues - Arrange crockery so that items do not touch each other. Concave items (e.g. bowls, cups) must be arranged facing downwards in the rack. - If necessary, use more detergent, observing the manufacturer's indications as regards dosage. Always store detergent in a dry place and do not store it for excessively long periods of time. - For heavily soiled crockery, select a wash programme with a higher temperature (see table 1.
Printed in Italy 12/10 5019 796 01019 n GB
