Owners Manual
Table Of Contents
- COOKTOP SAFETY
- Cooktop Safety
- COOKTOP MAINTENANCE AND CARE
- General Cleaning
- INSTALLATION INSTRUCTIONS
- REQUIREMENTS
- Tools and Parts
- Location Requirements
- Venting Requirements
- Venting Methods
- Electrical Requirements
- Gas Supply Requirements
- INSTALLATION
- Prepare Cooktop
- Install Cooktop
- Make Gas Connection
- Attach Cooktop to Countertop
- Electronic Ignition System
- Complete Installation
- SÉCURITÉ DE LA TABLE DE CUISSON
- Sécurité de la table de cuisson
- ENTRETIEN ET RÉPARATION DE LA TABLE DE CUISSON
- Nettoyage général
- INSTRUCTIONS D’INSTALLATION
- EXIGENCE
- Outils et pièces
- Exigences d'emplacement
- Exigences concernant l'évacuation
- Méthodes d'évacuation
- Spécifications électriques
- Spécifications de l’alimentation en gaz
- INSTALLATION
- Préparation de la table de cuisson
- Installation de la table de cuisson
- Raccordement au gaz
- Fixer la table de cuisson la le comptoir
- Système d’allumage électronique
- Achever l’installation
12
6. Place plenum on bottom of cooktop with round opening to the
motor wire harness.
NOTE: All holes are pre-drilled. If all 6 holes do not line up,
reverse plenum.
7. Using a 1/4" (6.4 mm) nut driver, screw in the 6 screws from
the literature pack to attach plenum.
8. Remove access panel from plenum using a 1/4" (6.4 mm) nut
driver and set aside.
9. Remove four locking nuts and four washers from literature
bag.
NOTE: Remove the four protective caps from the motor
mounting posts.
10. Place blower motor on plenum.
11. Install and finger-tighten the four washers and locking nuts
that were removed through the opening of the motor access
panel. Do not over-tighten to allow for motor to rotate.
12. Connect blower electrical connector to cooktop.
13. Using a 1/4" (6.4 mm) nut driver, screw the electrical junction
cover to the burner box with 2 screws.
14. Remove the two screws located in each side of the cooktop
burner box.