Installation Instructions

11
13. Using a 1/4" (6.4 mm) nut driver, screw the electrical junction
cover to the burner box with 2 screws.
14. Remove the two screws located in each side of the cooktop
burner box.
Install Cooktop
Install the pressure regulator to cooktop before installing the
cooktop into the cabinet. See the “Make Gas Connection”
section.
1. Install the pressure regulator with the arrow pointing up
toward the bottom of the cooktop base and in a position
where you can reach the regulator access cap.
IMPORTANT: All connections must be wrench-tightened. Do
not make connections to the gas regulator too tight. Making
the connections too tight may crack the regulator and cause
a gas leak. Do not allow the regulator to turn on the pipe
when tightening fittings.
Use only pipe-joint compound made for use with Natural and
Propane gas.
Do not use TEFLON
®†
tape. You will need to determine the
fittings required depending on your installation.
2. Attach the 2 hold-down brackets to the burner box.
3. Using two or more people, lift the cooktop from packaging
foam and install the cooktop into the countertop cutout by
tilting 1 end of the cooktop into the cutout, then lowering the
other end into the cutout.
NOTE: Make sure that the front edge of the cooktop is
parallel to the front edge of the countertop. If repositioning
is needed, lift entire cooktop up from cutout to avoid
scratching the countertop.
4. Rotate motor to align with duct work and attach ducting.
5. Fully tighten motor and, using a 1/4" (6.4 mm) nut driver,
reattach motor access cover with two screws.
IMPORTANT: Verify that the motor access cover is fully
tightened and back on the plenum.
6. Select bracket mounting holes that will allow the bracket to
extend far enough out from the cooktop for the installation of
#10-16 x 3" (7.62 cm) clamping screws.
7. Attach brackets to cooktop base bottom with bracket
attachment screws using the bracket mounting holes
selected in Step 6. Securely tighten screws.
8. Install grease filter.
NOTES:
■ The filter should always be placed at an angle. As you
face the front of the cooktop, the top of the filter should
rest against the right side of the vent opening.
■ The bottom of the filter should rest against the left side
of the vent chamber at the bottom.
■ If the filter is flat against the fan wall, ventilation
effectiveness will be reduced.
9. Install vent grille.
WARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
A
B
C
D
A. Access cap
B. Rear of cooktop
C. Gas pressure regulator
D. Up arrow. Regulator must be installed with
arrow pointing up to cooktop bottom.
A
B
C
D
E
F
G
A. Cooktop
B. Cooktop base
C. Attachment screw
D. Clamping bracket (extends far
enough beyond cooktop base to
allow installation of clamping screws)
E. #10-16 x 3" (7.62 cm) clamping
screw (to be installed in “Attach
Cooktop to Countertop”)
F. Countertop
G. Foam seal
A
B
A. Plenum
B. Grease filter
†
®
TEFLON is a registered trademark of Chemours.