Use & Care Guide

26
5. Using the 2 screws, attach the base grille assembly to the
refrigerator as shown.
NOTE: Drive in the right side screw first.
A. Screws (2)
Install Odor Absorber (on some
models)
On some models, your refrigerator's accessory packet includes an
odor absorber, which must be installed prior to use. On some
models, the odor absorber is already installed at the factory.
The odor absorber reduces the buildup of odors. This helps to
maintain a cleaner environment inside the refrigerator.
Installing the Odor Absorber (on some models)
The absorber should be installed behind the vented door, which is
located (depending on your model) along either the rear or left
interior wall near the top of the refrigerator compartment.
1. Remove the odor absorber from its packaging.
2. Snap the absorber in to place.
3. Pinch the tabs on the odor absorber to remove the absorber.
Replacing the Odor Absorber
The disposable odor absorber should be replaced every 6
months, when the status indicator has completely changed from
white to red.
To order a replacement odor absorber, see “Accessories” in the
User Instructions or User Guide.
� Remove the old odor absorber by squeezing in on the side
tabs.
� Remove the old status indicator.
� Install the new odor absorber and status indicator using the
instructions in the previous sections.
Complete Installation
1. Turn the water supply line valve to the "Open" position.
2. Turn the refrigerator switch to the ON position. See "Power
On/Off Switch" in the Use & Care Guide for instructions. Wait a
few minutes. Check the water line connections for leaks.
3. Remove all boxes, parts packages and packing materials from
the interior of the refrigerator. See the "Cleaning" section in the
Use & Care Guide for instructions. Remove the film and
cardboard from the grille and doors or door frame, depending
on your model.
4. Install the shelves and bins in the refrigerator and freezer
compartments.
5. The controls are preset at the factory to the midpoint setting.
Make sure the compressor is operating properly and that all
the lights are working.
6. Flush the water system before use. See "Water System
Preparation."
To get the most efficient use from your new built-in refrigerator,
read the Use & Care Guide. Keep Installation Instructions and
Use & Care Guide near the built-in refrigerator for easy reference.
Water System Preparation
Please read before using the water system. Follow the directions
specific to your model.
Style 1 (Dispenser Models)
IMPORTANT: After connecting the refrigerator to a water source
or replacing the water filter, follow the steps below to make sure
that the water system is properly cleaned. This will flush air from
the filter and water dispensing system, and prepare the water filter
for use.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used
on disinfected waters that may contain filterable cysts.
NOTE: If your model has a base grille filter system, make sure the
base grille filter is properly installed and the cap is in the horizontal
position.