Manual

==Carefully lift grill grates off of grill
area and set aside.
==Remove sear plates and set aside.
searplate
0 • Remove tiedowns from burners
and warming shelf.
_warming
shelf
remove J
Uedowos
remove
tiedowos
I burner
1 • Reinstall sear plates. Make
sure sear plates are resting on pins.
If convertedto
L.P.Gas
Explosion Hazard
Securely tighten all gas connections.
If connected to LP, have a qualified
)erson make sure gas pressure does
not exceed 11" (28 cm) water column.
Examples of a qualified person
include:
licensed heating personnel,
authorized gas company personnel
and,
authorized service personnel.
Failure to do so can result in death,
explosion, or fire.
• Make gas connections.
L,P./propane(supplied): The 20 lb. L.R
tank is located in the compartment below
grill. Remove tank and take to an
authorized dealer to be filled. Reinstall
tank and screw the hose/regulator
assembly to tank as shown.
The pressure
hose/regulator
regulator and assembly
hose assembly f
supplied with the
grill must be used.
Replacement
pressure regulator
and hose
assembly specific to your model, is
available from your outdoor grill dealer.
If converting to natural gas, see
conversion kit requirements and "Gas
supply requirements" section. Follow
instructions included with kit.
==Turn on the gas supply. Wait a few
minutes for gas to move through the gas
line.
• Test all connections by brushing on
an approved non-corrosive leak-detection
solution. Bubbles will show a leak. Correct
any leak found.
= Go to "Checking and adjusting the
burners" section.
2 • Carefully slide grill completely
into outdoor enclosure.
3 • Now go to the "Checking and
Adjusting Burners Section."
10