Specification

PRODUCT MODEL NUMBERS
Bottom Mount Built-In Refrigerator
KBBX104E
Electrical: A 115 volt, 60 Hz., AC only, 15- or 20-amp fused, grounded electrical
supply is required. It is recommended that a separate circuit serving only your
refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do
not use an extension cord.
IMPORTANT: If this product is connected to a GFCI (Ground Fault Circuit
Interrupter) protected outlet, nuisance tripping of the power supply may occur,
resulting in loss of cooling. Food quality and flavor may be affected. If nuisance
tripping has occurred, and if the condition of the food appears poor, dispose of it.
NOTE: Before performing any type of installation or cleaning, disconnect power
at the circuit breaker box.
When you are finished, reconnect power at the circuit breaker box. Then reset the
control to the desired setting.
PRODUCT DIMENSIONS
LOCATION REQUIREMENTS
n The unit is 69¹¹⁄₁₆" (177.0 cm) high, 21⁹⁄₃₂" (54.0 cm) wide, and 21¹⁵⁄₃₂"
(54.5 cm) deep (front-to-back).
n The refrigerator door (including hinges (x2)) is 20⁵⁄₈" (105.75 cm) high.
The freezer door (including hinges (x2)) is 26⁵⁄₁₆" (66.85 cm) high.
The space between the refrigerator and freezer doors is 2³⁄₈"
(6.0 cm). The space between the door hinges is ¹³⁄₃₂" (1.0 cm).
Dimension Table
A 70" (1776 mm) I
2³⁄₈" (60 mm)
B 22" (560 cm) J
¹⁄₁₆" (2 mm)
C
minimum 21⁷⁄₈" (555 mm)
K 42" (1057 mm)
D
minimum 20⁷⁄₁₆" (520 mm)
L
³⁄₁₆" (10 mm)
E minimum 2" min. (50 mm) M 28" (703 mm)
F 69" (1770 mm) N 26" (688 mm)
G 21¼" (540 mm) O
1³⁄₁₆" (30 mm)
H 21½" (545 mm)
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10745310C
4/15
n It is recommended that you do not install the refrigerator near an oven,
radiator, or other heat source.
n Do not install in a location where the temperature will fall below 55°F (13°C).
n Floor must support the refrigerator weight, more than 600 lbs (272 kg), door
panels and contents of the refrigerator.
OPENING DIMENSIONS
This refrigerator is designed to be installed inside a frame that fits between
kitchen cabinets. The inside of the frame should be a minimum of 69¹⁵⁄₁₆"
(177.6 cm) high, 22¹⁄₁₆" (56.0 cm) wide, and 21⁷⁄₈" (55.5 cm) deep (front-to-back).
For proper ventilation, you must allow adequate unobstructed space behind the
refrigerator and below and above the frame. Air enters below the refrigerator and
exits above it.
n Allow a clearance minimum of 2" (50 mm) at the top of the frame.
n The minimum depth of the base of the frame is 20¹⁄₂" (520 mm) (front to back).
n The base can be as desired, but height should match height of toe kick of
surrounding cabinets. A vent with an opening of at least 31 sq in. (200 sq. cm)
is required for proper ventilation.
n If the space between the top of the frame and the ceiling is open air, allow a
minimum of 7⁷⁄₈" (20.0 cm) above the refrigerator.
1
/16"
(2 mm)
3
/8"
(9 mm)
1
/8"
(4 mm)
A
D
C
B
E
G
H
F
I
J
K
L
N
M
O
If the space between the top of the frame and the ceiling is enclosed as part of
the surrounding cabinetry, a vent with an opening of at least 31 sq. in.
(200 sq. cm) is required. The bottom of the vent must be a minimum of 7⁷⁄₈"
(20.0 cm) above the refrigerator.
NOTE: Vent covers are not supplied with the unit.
31"
2
(200 mm
2
)
31"
2
(200 mm
2
)
3
1"
2
(200 mm
2
)
31"
2
(200 mm
2
)
3
1"
2
(200 mm
2
)
31"
2
(200 mm
2
)
7
7
/8"
(200 mm)
7
7
/8"
(200 mm)
7
7
/8"
(200 mm)
7
7
/8"
(200 mm)
7
7
/8"
(200 mm)