Health and safety
EN
3
SAFETY INSTRUCTIONS
IMPORTANT TO BE READ 
AND OBSERVED
Before using the appliance read 
these safety instructions.
Keep them for future reference.
These instructions and the 
appliance itself provide 
important safety warnings, to be 
observed at all times.
The manufacturer declines any 
liability for failure to observe 
these safety instructions, for 
inapropriate use of the 
appliance or incorrect setting of 
controls.
SAFETY WARNINGS
Very young (0-3 years) and 
young children (3-8 years) shall 
be kept away from the appliance 
unless continuously supervised.
Children from 8 years old and 
above and persons with reduced 
physical, sensory or mental 
capabilities or lack of experience 
and knowledge can use this 
appliance only if they are 
supervised or have been given 
instructions on safe use and 
understand the hazards 
involved. Children must not play 
with the appliance. Cleaning and 
user maintenance must not be 
carried out by children without 
supervision.
WARNING: The appliance and 
its accessible parts become hot 
during use, children less than 8 
year of age shall be kept away 
unless continuously supervised.
WARNING: Avoid touching 
heating elements or interior 
surface - risk of burns.
Never leave the appliance 
unattended during food drying.
If the appliance is suitable for 
probe usage, only use the 
temperature probe 
recommended for this oven.
Keep clothes or other ammable 
materials away from the 
appliance, until all the 
components have cooled down 
completely.
Overheated oils and fats catch 
re easily. Always be vigilant 
when cooking food rich in fat, 
oil or when adding alcohol (e.g. 
rum, cognac, wine) - risk of re.
Use oven gloves to remove pans 
and accessories, taking care not 
to touch the heating elements.
At the end of cooking, exercise 
caution when opening the door, 
by letting the hot air or steam 
exit gradually before accessing 
the appliance.
Do not obstruct hot air vents at 
the front of the oven.
PERMITTED USE
CAUTION: The appliance is not 
intended to be operated by 
means of an external timer or 
separate remote controlled 
system.
This appliance is solely for 
domestic, not professional use.
Do not use the appliance 
outdoors.
Do not store explosive or 
ammable substances such as 
aerosol cans and do not place or 
use gasoline or other ammable 
materials in or near the 
appliance: a re may break out if 
the appliance is inadvertently 
switched on.
No other use is permitted 
(e.g.heating rooms).
INSTALLATION
The appliance must be handled 
and installed by two or more 
persons. Use protective gloves 
to unpack and install the 
appliance.
Installation and repairs must be 
carried out by a qualied 
technician, in compliance with 
the manufacturer’s instructions 
and local safety regulations. Do 
not repair or replace any part of 
the appliance unless specically 
stated in the user manual.
Children should not perform 
installation operations. Keep 
children away during 
installation. Keep the packaging 
materials (plastic bags, 
polystyrene parts, etc.) out of 
reach of children, during and 
after the installation.
After unpacking the appliance, 
make sure that it has not been 
damaged during transport. In 
the event of problems, contact 
the dealer or your nearest After-
sales Service.
The appliance must be 
disconnected from the power 
supply before any installation 
operation.
During installation, make sure 
the appliance does not damage 
the power cable.
Only activate the appliance 
when the installation has been 
completed.
After installation, the bottom of 
the appliance must no longer be 
accessible.
Carry out all cabinet cutting 
works before tting the 
appliance in the furniture and 
carefully remove all wood chips 
and sawdust.
Do not obstruct the minimum 
gap between the worktop and 
the upper edge of the oven.
Only remove the oven from its 
polystyrene foam base at the 
time of installation.
Do not install the appliance 
behind a decorative door - Risk 
of re.
ELECTRICAL WARNINGS
For installation to comply with 
current safety regulations, an 
omnipolar switch with minimum 
contact gap of 3 mm is required 
and the appliance must be 
earthed.
If the power cable is damaged, 
replace with an identical one. 
The power cable must only be 
replaced by a qualied 
technician in compliance with 
the manufacturer instruction 
and current safety regulations. 
Contact an authorized service 
center.
EN








