Model 5KFP1335 W10505785Av1.
Food Processor Instructions Table of Contents FOOD PROCESSOR SAFETY Important Safeguards........................................................................................................5 Electrical Requirements....................................................................................................6 Electrical Equipment Waste Disposal................................................................................6 PARTS AND FEATURES Food Processor Parts.....................................
English Food Processor Safety IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all instructions. 2. To protect against risk of electrical shock, do not put Food Processor in water or other liquid. 3.
Food Processor Safety IMPORTANT SAFEGUARDS 15. Never feed food by hand. Always use the food pusher. 16. Do not attempt to defeat the cover interlock mechanism. 17. This product is designed for household use only. SAVE THESE INSTRUCTIONS Electrical Requirements Voltage: 220-240 Volts Frequency: 50/60 Hertz Wattage: 300 Watts NOTE: If the plug does not fit in the outlet, contact a qualified electrician. Do not modify the plug in any way.
Parts and Features Work Bowl Cover with 3-in-1 Feed Tube Accessory Case 3-Piece Food Pusher English Food Processor Parts 3.1 L (13-Cup) Work Bowl Externally Adjustable Slicing Control Base 950 mL (4-Cup) Mini-Bowl and Mini-Blade Egg Whip Externally Adjustable Slicing Disc (Thin to Thick) Reversible (2 mm and 4 mm) Shredding Disc Dough Blade Slicing Adapter Drive Adapter Disc Adapter Stainless Steel Multipurpose Blade 7 W10505785Av1.
Parts and Features Important Food Processor Features Externally Adjustable Slicing Control KitchenAid’s exclusive externally adjustable slicing disc allows you to adjust slicing thickness from thin to thick, without having to remove the blade assembly.
Accessories Disc Assembly Overview Adjustable Slicing Disc English There are two different disc adapters included with the food processor. One is used exclusively with the adjustable slicing disc. The other is used with the Reversible Shredding Disc and all other optional discs. Reversible Shredding Disc Slicing Adapter Disc Adapter Drive Adapter Drive Adapter Properly assembled 9 W10505785Av1.
Accessories Accessories Selection Guide Action Mince Chop Puree Setting Food Cheese Chocolate Fruit Fresh Herbs Nuts Tofu Vegetables Meat Fruit (soft) Potatoes Tomatoes Vegetables (soft) Slice Thick OR Mini-bowl and Mini Multipurpose Stainless Steel Blade Shred Fine Adjustable Slicing Disc Cheese Chocolate Fruit (hard) Vegetables (hard) Potatoes Vegetables (soft) Shred Medium Multipurpose Stainless Steel Blade Pasta Sauce Pesto Salsa Sauces Cake Batter Pie Dough Mix Slice Thin Accessory R
Preparing the Food Processor for First Use English 2. Lift out the mini-bowl. Before First Use Before using your Food Processor for the first time, wash the work bowl, work bowl cover, mini-bowl, feed tube pushers, discs, and blades either by hand or in the dishwasher (see “Cleaning the Food Processor”). Removing the Work Bowl Cover from the Work Bowl Your Food Processor is shipped with the work bowl cover installed on the work bowl, with the mini-bowl inside the work bowl.
Setting Up Your Food Processor Attaching the Work Bowl 1. Place the Food Processor on a dry, level countertop with the controls facing forward. Do not plug in the Food Processor until it is completely assembled. 2. Place the work bowl on the base, aligning the raised portion with the indentation on the base. The center hole should fit over the power shaft. Attaching the Work Bowl Cover NOTE: Be sure to install the desired accessory before attaching the work bowl cover. 1.
Setting Up Your Food Processor IMPORTANT: The adjustable slicing disc can only be installed in one direction. TIP: You may need to turn the disc/drive adapter until it drops down into place. 4. Install the work bowl cover, being sure it locks into place. 1. With the work bowl installed, place the drive adapter on the power shaft of the base. 2. Holding the adjustable slicing disc by the 2 finger grips, align the pins onto the adjustable slicing disc adapter into the L-slots on the disc.
Setting Up Your Food Processor Installing the Shredding Disc IMPORTANT: When using the reversible shredding disc, have the desired side (medium/fine) facing UP. 3. With the work bowl installed, slide the drive adapter onto the power shaft. TIP: You may need to turn the disc/drive adapter until it drops down into place. 1. Holding the disc by the 2 finger grips, insert the disc adapter into the hole in the bottom of the disc. 4. Install the work bowl cover, being sure it locks into place. 2.
Setting Up Your Food Processor IMPORTANT: The multipurpose blade and dough blade can only be used with the work bowl. 1. Place the blade on the power shaft. 2. Rotate the blade so it falls into place on the power shaft. 3. Push to lock: press down firmly on the multipurpose blade until it is down as far as it will go. The multipurpose blade features an internal seal that fits tightly over the center of the work bowl. 4. Install the work bowl cover, being sure it locks into place.
Setting Up Your Food Processor Installing the Egg Whip IMPORTANT: The egg whip can only be used with the work bowl. 1. Be sure the egg whip is properly assembled. If the two pieces have been disassembled for cleaning, align the pin on the egg whip adapter with the slot on the egg whip, and rotate to lock into place. 2. With the work bowl in place on the base, place the egg whip on the power shaft. Using the 3-in-1 Feed Tube The 3-in-1 feed tube features a 3-piece food pusher.
Using Your Food Processor 1. To turn on the Food Processor, press the Speed 1 button (low speed, for soft food) or the Speed 2 button (high speed, for hard food). The Food Processor will run continuously and the indicator light will glow. 2. To stop the Food Processor, press the O (OFF) button. The indicator light will go out and the blade or disc will stop within a few seconds. 3. Wait until the blade or disc comes to a complete stop before removing the work bowl cover.
Using Your Food Processor 5. If using the mini-bowl, grasp and remove the bowl using the finger grips located along the top edge of the bowl. Removing Processed Foods 1. Press the O (OFF) button. 2. Unplug the Food Processor before disassembling. 3. Turn the work bowl cover to the left and remove. 6. Turn the work bowl to the left to unlock it from the base. Lift to remove. 4. If using a disc, remove it before removing the bowl. Holding the disc by the 2 finger grips, lift it straight up.
1. Press the O (OFF) button. 2. Unplug the Food Processor before cleaning. 3. Wipe the base and cord with a warm, sudsy cloth, and wipe clean with a damp cloth. Dry with a soft cloth. Do not use abrasive cleansers or scouring pads. 4. Please note these BPA-free bowls require special handling. If you choose to use a dishwasher instead of hand washing, please follow these guidelines. -- All parts are top rack dishwasher safe. -- Avoid laying the bowl on its side.
Tips for Great Results To chop nuts or make nut butters: Process up to 3 cups (710 mL) of nuts to desired texture, using short pulses, 1 to 2 seconds each time. For a coarser texture, process smaller batches, pulsing 1 or 2 times, 1 to 2 seconds each time. Pulse more often for finer texture. For nut butters, process continuously until smooth. Store in refrigerator. To chop cooked or raw meat, poultry or seafood: The food should be very cold. Cut in 1-inch (2.5 cm) pieces.
To slice cooked meat or poultry, including salami, pepperoni, etc.: Food should be very cold. Cut in pieces to fit feed tube. Process food using firm, even pressure. To shred spinach and other leaves: Stack leaves. Roll up and stand up in feed tube. Process using even pressure. To shred firm and soft cheeses: Firm cheese should be very cold. For best results with soft cheeses, such as mozzarella, freeze 10 to 15 minutes before processing. Cut to fit feed tube. Process using even pressure.
Tips for Great Results • When preparing a cake or cookie batter, use the multipurpose blade to cream fat and sugar first. Add dry ingredients last. Place nuts and fruit on top of flour mixture to prevent overchopping. Process nuts and fruits, using short pulses, until blended with other ingredients. Do not overprocess. • When shredded or sliced food piles up on one side of the bowl, stop the processor and redistribute the food using a spatula.
Troubleshooting If the work bowl cover won’t close when using the disc: • Make sure the disc is installed correctly, with the raised nub on top, and is positioned properly on the drive adapter. English Food Processor not shredding or slicing properly: • Make sure the raised-blade side of the disc is positioned face up on the common adapter. • If using the adjustable slicing blade, make sure it is set to the correct thickness. • Make sure ingredients are suitable for slicing or shredding.
Service and Warranty Service Centers All service should be handled locally by an Authorized KitchenAid Service Center. Contact the dealer from whom the unit was purchased to obtain the name of the nearest Authorized KitchenAid Service Center. In the U.K.: Call: 0845 6011 287 In Ireland: M.X. ELECTRIC Service Department 25 Alymer Crescent Kilcock, Co. KILDARE Call: 87 2581574 Fax: 1 628 4368 In Australia: Call: 1800 990 990 In New Zealand: Call: 0800 881 200 Customer Service In U.K.
www.KitchenAid.eu W10505785A © 2012. All rights reserved. Specifications subject to change without notice. W10505785A_ARv7-Outlined vs4.
