User Manual

KisanKraft
®
KK-WPE-550F 750F-1100F 1500F
: www.kisankraft.com
: [e-mail]
: +91.80. 6835 7800
Page 8 of 20
Safety Instructions
Danger of death
Violating these safety instructions
may result in death through
electrocution
• Check the power cord with mains plug for damage before every use. If the power cord is
damaged, please arrange immediately for the exchange by an authorized customer service
or a skilled electrician.
• All electrical sockets should be fixed in an area that is protected against floods.
• Unsuitable extension cables can be hazardous. Only use extension cables outdoors which
have been approved for this purpose and labelled with a sufficient cable cross-section. The
plug and coupling of the extension cable used must be spray watertight.
• Do not use the mains cable or the cable of the level sensor to transport or fasten the
appliance.
• To separate the machine from the mains, pull the plug and not the power cord.
• Do not scrape the power cord across sharp edges and ensure that it does not get pressed.
• The voltage indicated on the type of plate must correspond to the voltage of the electrical
source.
• To avoid risks, all repairs and replacement of spare parts may only be carried out by the
authorized customer service personnel.
• Follow the rules for electrical safety of equipment: When pumping out swimming pools,
garden ponds and fountains, only using an earth-leakage circuit breaker with a nominal
leakage current of max. 30 mA with the immersion pump. Do not operate the pump if there
are persons located in the swimming pool or the garden pond.
For safety reasons, we recommend that you operate the appliance only via an earth-
leakage circuit breaker (max. 30 mA).
The electrical connection of the system may only be performed by a qualified electrician.
Please follow the respective national regulations!
• This device is not intended for use by persons (including children) with reduced physical,
sensory, or mental abilities or lacking experience and/or knowledge, unless they are
supervised by a person responsible for their safety or are instructed by these persons on
the use of the device. Children should be supervised, to ensure that they do not play with
the device
• The submersible motor-driven pump must be protected from frost.
• The pump must be protected from running dry.
START UP
Please follow the safety instructions before start-up!
Please keep in mind that the label "Nameplate" may not be removed from the pump. If the
label is removed, there will be no more warranty for the tightness of the pump.
KisanKraft
®
KK-WPE-550F 750F-1100F 1500F
: www.kisankraft.com
: [e-mail]
: +91.80. 6835 7800
Page 13 of 20
Technical Specifications
Model
KK-WPE-
550F
KK-WPE-
750F
KK-WPE-
1100F
KK-WPE-
1500
Electric Motor
Power
0.55 kW
0.75 hp
0.75 kW 1
hp
1.1 kW 1.5
hp
1.5 kW 2
hp
Rpm
2850
Type
Thermal protector for single phase
Poles
Two Pole induction motor
Voltage
220V-240V
Frequency
50 Hz
Ampere
5.1A
5.9A
7.6A
10.2A
Temperature (max)
Liquid temperature up to 35 °C Max
Ambient temperature
40°C
Winding
Copper
Insulation
B
Protection
IP68
Centrifugal Water Pump
Max Immersion dept
5 m
Cable
6m power cable with plug
Pump body / impeller
Cast iron
Max Head:
9.5 m
10.8 m
13.5 m
15 m
Min. Head
3.5 m
4 m
4.5
6.5
Voltage
550 W
750 W
1100 W
1500 W
Pump Delivery Size
2”
Max Flow Rate:
400 L/min
400 L/min
500 L/min
600 L/min
Note: Specifications are subject to change without prior notice.