User Manual

KisanKraft
®
Centrifugal Water Pump for
Agriculture
KK-WPE-800C,1100C,1500C
: www.kisankraft.com
: [e-mail]
: +91.80. 6835 7800
Page 10 of 20
ELECTRICAL SAFETY
Always check that the power supply corresponds to the voltage
on the rating plate.
DESCRIPTION
1. Motor housing
2. Water inlet
3. Water outlet
4. Cable & plug
5. Floating switch
6. Carrying handle
Installation
Connecting the outlet pipe
■
Connect the outlet pipe to the outlet opening.
Please note! You should never install the pump by suspending it unsupported from its delivery
pipe or power cable. The submersible motor pump must be suspended from the specially provided
handle or be placed on the bottom of the shaft. To guarantee that the pump works properly, the
bottom of the shaft must be kept free of sludge and dirt of all kinds.
If the level of water sinks too far, any sludge in the shaft will dry out quickly and stop the pump from
starting up. Therefore, it is necessary to check the submersible motor pump regularly (by carrying
out start-up tests). The floater is adjusted in a way that the pump can immediately be started
Note! The pump shaft should have minimum dimensions of 40 x 40 x 50 cm, so that the floating
switch can move freely
.
Main’s supply
Your new submersible pump is equipped with a shock-proof plug according to regulations. The
pump is designed to be connected to a safety socket of 220-240V~ 50Hz.
Important Note!
If the mains cable or plug suffers any damage from external action, repairs to the cable are
prohibited.
KisanKraft
®
Centrifugal Water Pump for
Agriculture
KK-WPE-800C,1100C,1500C
: www.kisankraft.com
: [e-mail]
: +91.80. 6835 7800
Page 11 of 20
SETTING TO WORK
After having read these instructions carefully, you can set your pump to work, reconsidering the
following:
• Check if the pump rests on the ground of the shaft.
• Check of pressure cord has been attached properly.
• Make sure that the electrical connection is 220-240V~ 50 Hz.
• Check if socket is in good condition.
• Make sure that water and humidity can never come to the mains supply.
• Avoid pump running dry
Before installing or moving the pump always remove
the mains plug from the wall socket
Switching on and off
• To switch on the pump, insert the mains plug in the wall socket.
• To switch off the pump, remove the mains plug from the wall socket. The pump only
operates when the float switch floats. This prevents the pump from running dry during
operation