User Manual

KisanKraft
®
Tea-Leaf Harvester
KK-TH-33A
: www.kisankraft.com
: [e-mail]
: +91.80. 6835 7800
Page 12 of 20
MAINTENANCE AND ADJUSTMENT
Blade adjustment
The blade can be used for a long time. When you check that blade is not as good
as before, please adjust the blasé as follow steps.
Adjustment steps:
(1) Loosen the nuts on the blade.
(2) Use the screwdriver to screw the bolt until it is stationary, and then twist back
about ¼.
(3) Fix the screw with a screwdriver and tighten the nut.
(4) After adjusting the above steps, lubricated the oil.
(5) Please turn off the power after the machine runs for 3 minutes, touch the bolt
with your hands, if it is still hot, please adjust it again, if it is too hot, please put
it aside, cool it down and repeat the previous step.
The blade bolt is easy to wear and tear. Please consider replacing the blade
when the blade noise increases, to extend the service life of the machine.
KisanKraft
®
Tea-Leaf Harvester
KK-TH-33A
: www.kisankraft.com
: [e-mail]
: +91.80. 6835 7800
Page 9 of 20
TROUBLES AND REMEDIES
NOTE: the battery tea harvester blades are very sharp and can cause severe injuries,
even if power is off and blades are not moving. Avoid touch blades, please wear gloves
to protect your hands. Place blade cover on blades and add oil when transporting or
storing unit
Problems
Possible Cause
Correction
1.MACHINE WILL
NOT START
a. Plug loosened
a. Plug in the cable plug
b. Wires inside the machine fall
off
b. Connecting the wires
c. batteries are partially
disconnected
c. Measure the voltage
between the poles with
multimeter, if not shown, connect
the inspection leads and
connect them.
d. The blade bolts are screwed
tightly
d. Loosen blade bolt (refer to
adjustment of blade in
manual)
e. Carbon brush has worn away
and
is out of contact
e. Replace carbon brush
f. Damaged rotor
Replace rotor
1.NOISE
a. Gear wear
a. Replace gear
b. Blade bolt wear
b. Replace the blade
bolt(refer to the
instruction manual for blade
adjustment)
c. Bearings wear
Replace bearing
3.MACHINE IS
OVERHEAT
a. The bolts are screwed tightly,
resulting in larger blade resistance
and consumption of motor power.
Loosen blade bolt (refer to
adjustment of blade in manual)
b. Blades are blocked
b. max cutting dia.:< 8mm
c. Long-running operations
c. Normally, you should rest
10-20
minutes every 30 minutes
after work.