User Manual

KisanKraft
®
Tea-Leaf Harvester
KK-TH-33A
: www.kisankraft.com
: [e-mail]
: +91.80. 6835 7800
Page 10 of 20
TROUBLES AND REMEDIES
Checking
Possible Cause
Correction
Fasteners
Shedding, loose
Fastening
Gearbox
Without lubricating oil
Lubricated the oil
Blade
Not sharp
Sharpening blade
Without lubricating oil
Oil injection
Blade adjusting nut
Blade clearance
adjustment
is not good
Adjustment
Battery is full or not
Pre charge
Charging
Machine running
Abnormality in the noise
vibration
Maintenance
KisanKraft
®
Tea-Leaf Harvester
KK-TH-33A
: www.kisankraft.com
: [e-mail]
: +91.80. 6835 7800
Page 11 of 20
OPERATIONS
1. ALWAYS maintain a minimum safety zone of 45 feet (15 meters) from where you
are working.
Don’t allow others to enter the safety zone unless you have shut the tea
harvester off and the blades have completely stopped moving, also pay attention to
the animals around you.
2. Plug the dc tea plucking machine cable into the battery socket.
3. Turn on/off switch: turn on the switch button on the handle, the tea plucking
machine starts working, turn off the switch button, and the machine will be turned
off.
Before starting the machine, please check if all accessories used have been
installed properly; before the start of the operation, it is determined that the
blade does not touch any object, such as branches, stones, etc. If there are any
problems, please turn off the switch immediately and pull the cable plug.
When operating, be careful not to touch lubricant, resin, grease, to ensure a stable
and balanced footing
MATTERS NEEDING ATTENTION
1. The blades must be kept sharp at all times to achieve good work efficiency. The
gap between the cutter and blade should not be too large, but it should not be
too small. It is difficult to cut leaves off if it has too large clearance. If with too
small a gap, the machine doesn’t work.
2. Only use the machine when the light is sufficient, and the vision is clear. Please
pay attention to whether the ground is wet and slippery, and if there is ice (there
is danger of slipping down).
3. You must have a safe foothold, do not stand in a semi solid, unstable place to
work, and pay attention to balance at all times.
4. Keep all parts of the body away from the cutting blade. Do not remove cutting
materials (leaves) or hold them while the blade is moving. Make sure the switch
is off when removing the clog. Misuse may result in serious or fatal injuries.
5. ALWAYS hold the unit securely with both hands after it starts to ensure it is
within the control range.
6. If the cable is damaged or cut, unplug it immediately.
7. If come across a stone or hard object in use, please turn off the machine
immediately and check if the tool is damaged. Please repair or replace the
damaged blade before using it again.
8. Take regular rest breaks. You should normally rest for 10-20 minutes after
working every 30 minutes.
9. If there are any problems in use, the power switch must be switched off
immediately.