User Manual

KisanKraft
®
CHAFF CUTTER
KK-FMC-500
: www.kisankraft.com
: [e-mail]
: +91.80. 6835 7800
Page 10 of 16
Operation Instruction
1. Make sure the motor run in the correct direction.
2. Put the control lever at “L” or “S”, then start the motor.
3. Feeding raw materials evenly. If the material is blocked, stop the machine totally, then
remove the materials.
4. Avoid metal and stone from feeding materials.
5. Hands are not allowed into the feeding protective cover when the machine is running.
6. It is forbidden to use a stick & iron object to feed the raw materials.
7. Please do not open the upper cover when the machine is running.
8. Please cut off the power source, and make all parts stop working before maintaining and
repairing.
9. Lubricating the gears with engine oil every 5-7 days
.
KisanKraft
®
CHAFF CUTTER
KK-FMC-500
: www.kisankraft.com
: [e-mail]
: +91.80. 6835 7800
Page 7 of 16
Before Getting Started
Please read this instruction manual carefully before use.
This instruction manual is used to explain the technical performance, use method,
connection and installation, common faults in operation of the machine. It guides users to
proper operation, use, repair and maintenance. Proper use of the machine can extend its
service life and reduce the failure rate.
Safety Precautions
1. The product manual must be read carefully before using the machine. And adjust and
maintain according to the regulations.
2. Before starting, check the following
a) Whether the key parts are solid?
b) Is the cutter wheel steering consistent with the specified direction?
c) Is the upper casing locked?
d) Is the Safety shield closed?
3. Do not open the safety shield when the machine is running.
4. If abnormal conditions are found, it is necessary to stop the inspection immediately. It
is strictly forbidden to rectify the fault when the machine is running.
5. When the feed port is clogged, it is strictly forbidden to help feed with your hands or
sticks.
6. It is forbidden to mix iron objects, stones and other debris into the materials.
7. Workplace should be well-ventilated and fire-proofed.
8. Reasonable matching power should be ensured, do not increase spindle speed
arbitrarily.
9. The following people are not allowed to operate the machine:
Minor’s drunken people and People with diseases that affect judgment,
10. Before normal operation, please run for 3 to 5 minutes, and there be no abnormality
before you can feed the material. When feeding, it should be evenly distributed and
should not be overloaded.
11. Note: “When feeding port is blocked, it is forbidden to feed with hand or stick." It is
strictly forbidden to mix iron and stone and other debris into the material" and "the