Instruction Manual

Page - 19

25LED INSTALLATION:

This is a special unit designed for a split

voltage input of 6 volts for low intensity

running light and 12 volts step-up for

the brakes. 25LED modulator fits the

OEM Wing-light for the GL1500 SE

models.

25LED can be plugged in-line with the

connector on the back of the trunk lid a

shown. Use Velcro strip to mount it.

2-pin input connector is polarized to

match with Gold Wing 1500 wiring. The

output pins are protected internally, so

reverse connection will not harm the

electronics. IF the spoiler LEDs do not

come on, check the output pins for

polarity and connection.

The Running Light Intensity Adjustment is not available on this unit.

 The step-up regulator of the SE models need minimum of 12.6 volts

input to function correctly. tailBlazer may not execute complete 4-sec

flash cycle without the engine running

 To minimize false triggering from CB transmit function, reroute the

coaxial cable of the antenna which runs along the left hinge of the

trunk alongside the LED power wire. Separate them as much as

possible to eliminate any cross talk.