Instruction Manual

Page - 17
200GW INSTALLATION:
This is a heavy-duty unit designed
to handle up to (4) brake bulbs.
On most models, access to the
brake wire can be found under the
seat. Please follow the electrical
circuit diagram of your model and
use a voltmeter to identify the
correct wire and the proper
location to splice-in.
For most multiple bulb type of
taillight arrangements, there’s
typically a connector in the
harness before it is split-up to feed
different bulbs.
For GL 1800 please refer to Goldwing section.
Once you have identified the brake wire and chosen the correct location
to make the splice, cut and prepare the wire ends as shown here. If you
plan to use the rubber boot, feed
the wires though first by piercing a
small hole at the tip of the boot.
Next, Insert the wire-ends and
screw-in (3) connections as
follows:
 BRAKE INPUT - is for the stripped wire-end that supplies power.
 OUTPUT to BULBS - is for the stripped wire-end going to the bulbs.
 GROUND - is for the wire supplied with ring for attaching to chassis.
t in an appropriate location – away from
high heat or direct water spray.
Use the Velcro to mount the uni