Instruction Manual

Page - 12
100HD-M
(1) WIRE SPLICE-IN
tailBlazer
100HD-M has (3) screw-in terminals:
 Input Terminal: for Brake Input
 Output Terminal: for Output to the bulbs
 Ground Terminal: for the Ground
 Modulates the Brake bulb for a 4-sec Deceleration Warning
Trigger voltage: 10.9 volts
100HD-M has a modified ballast circuit to allow monitoring voltage
pass-thru. This allows bulb filament detection. If your bike has
dash warning that indicates burned-out brake bulb, this unit is the
correct application. Max load is (3) brake bulbs.
DO NOT EXCEED THE RATED WATTAGE.
Warranty coverage will be denied, if unit is damaged from overload.