User Guide

If a pre-alarm is enabled, you hear pre-alarm alert tone before TOT time is up.
9. Scan
The radio scans to search for active channels. After finding an active channel, the radio dwells on it for
communication.
To start/stop scan, press the Function key programmed to scan.
10. Initiating a Call during Scan
During scan, you can press the PTT key to transmit on a preset channel.
Note: This channel is set by your dealer.
11. Stun/ Revive
The radio receives and decodes Kill and Revive signals from another radio, and performs accordingly.
When the radio is killed, it receives no signals but Revive.
When the radio is revived, it transmits and receives signals normally.
Note: This function is available in digital mode only, and is enabled by your dealer.
12. Emergency Alarm
Under emergency, you may send an emergency alarm by pressing the Function key programmed to send alarms.
To cancel an alarm, press the Function key programmed to exit emergency alarm.
You need to set an alarm mode and an alarm type.
 Alarm Mode
Emergency Alarm: The radio sends an alarm and then exit alarm state automatically.
Emergency Alarm + Emergency Call: After the radio sends an emergency alarm, press the PTT key to initiate an
emergency call.
Emergency Alarm + Auto Background Tone: The radio sends an emergency alarm and then background tone.
 Alarm Type
None: Alarm is disabled. You cannot send an alarm by pressing the Function key programmed to perform this
function.
Siren Only: In alarm state, siren plays locally and the control center cannot receive alarm signals.
Conventional: In alarm state, there is light and sound alert, and the radio can receive response from other members.
Secret: In alarm state, there is no light or sound alert, and the radio cannot receive response from other members.
Secret with Voice: In alarm state, there is no light or sound alert, but the radio can receive response from other
members.
Note:
An emergency alarm is a non-speech signal the radio sends to trigger another radio to give off an alarm.
You may set the above parameters using the programming software.
To guarantee emergent communication, an emergency call is prior to a common call.
Programmable Keys
You may have the Function key be programmed by your dealer to perform a specific function as needed.
Note:
Press: Press down and release quickly.
Hold down: Press down and hold for a period set through the CPS.
NO.
Function
Description
1
(Undefined)
Press the key, and the radio does not act.
2
High/Low Power
Switch to the high/low power.