Instruction Manual

ManualsBrandsKirby ManualsVacuumsSentria

Canister Cleaner & Attachments

PART THREE

Your Kirby

Sentria

system comes with a wide variety of

attachments for added versatility. In this section, we will

discuss the following:

Removing the Power Nozzle to Convert to a

Canister Cleaner

Using the Attachments

Using the Suction Control Grip

Using as a Blower Unit

Using the Portable Sprayer and the

Portable Shampooer

CONVERTING TO A CANISTER CLEANER/

INSTALLING THE ATTACHMENT HOSE

When using different cleaning attachments, the Attachment Hose is

connected to the front of the cleaner in place of the Power Nozzle



25 .

NOTE: When connecting the Attachment Hose, you may choose

between the Upright Handle



17 or the Portable Handle



15 . To install

the Portable Handle, see page 14.

To install the Attachment Hose, you must first convert to a Canister

by removing the Power Nozzle. To do so, press the Toe-Touch

Control

Bottom Pedal



9 all the way down until nozzle is fully raised.

Disengage Tech Drive

power assist by stepping on the gray “N”

side (marked “N” for Neutral) of the Tech Drive N/D Pedal



11 .

Turn the Sentria

system OFF by pressing the Power Switch



and then unplugging. ➤

Raise the Headlight Hood



21 and flip out the handle on the Belt

Lifter



20 . Use it to turn the Belt Lifter all the way to the left

(counter-clockwise) until the red arrows line up.

Unlock the Power Nozzle by turning the Accessory Lock



22 all

the way to the left (counter-clockwise). The Power Nozzle should

tip forward when it is released. Lift the nozzle away from the

Sentria system. ➤