Use and Care Manual
54
The Kirby Company
Q HOW DO I CLEAN OTHER HOME FURNISHINGS?
A Books and Bookcases:
1. Convert to a canister. See page 18.
2. AttachtheDusterBrushtotheendoftheAttachmentHoseand“dust”thebooksandbookcase.
3. OtheroptionsincludeusinganExtensionTubewiththeDusterBrushortheWall&
CeilingBrushtodustthebookcasetop.
Lampshades and Pictures:
1. Convert to a canister. See page 18.
2. AttachtheDusterBrushtotheSuctionControlGrip.ThenconnectthegriptotheAttachment
Hose.TesttheairflowbyregulatingtheSuctionControlValveontheSuctionControlGrip
before you dust your lampshades. Dust glass-covered artwork and picture frames.
Stereos and Computers:
1. Convert to a canister. See page 18.
2. AttachtheDusterBrushtotheSuctionControlGrip.Thenconnectthegriptothe
AttachmentHose.Testtheair-flowbyregulatingtheSuctionControlValveontheSuction
Control Grip before you dust your home electronics.
3. ConnecttheInflator/DeflatortooltotheendoftheAttachmentHosetodustbetweenthe
keys on a computer key board, faceplates on electronic gear and other hard-to-reach
small spaces.
Wicker Furniture and Baskets:
1. Convert to a canister. See page 18.
2.AttachtheDusterBrushtotheendoftheAttachmentHose.YourDusterBrushworkswell
between cracks and crevices on wicker and other irregular surfaces.
Drapes and Blinds:
1. Convert to a canister. See page 18.
2. Fordrapes,attachoneortwoExtensionTubestotheAttachmentHose.Connectthe
Suction Control Grip to the Extension Tube and then connect the Upholstery Nozzle (with
the faceplate attached). Test the air-flow by regulating the Suction Control Valve on the
Suction Control Grip before you dust your drapes and blinds.
The Suction Control Valve on the Suction Control Grip regulates airflow and prevents you
from pulling the drapes off the curtain rods.
Forblinds,followasimilarprocedureusingtheDusterBrushinsteadoftheUpholstery
Nozzle. If using the Suction Control Grip, make sure to completely close the Suction Control
Valve to maintain maximum airflow.
Q WHAT SHOULD I DO IF MY BAG SMELLS?
A Change it. Replace the bag when the dirt reaches the fill line. Do not overfill. Once the bag
is changed, roll your Ultimate G to an open area, put it in Neutral and turn it ON. Let it run in
Neutral for five minutes with the clean bag installed.
Make sure the Power Nozzle
o
25 is raised to its highest level by pressing the Toe-Touch
Control
TM
BottomPedal
o
9allthewaydown.DisengagetheBrushRollbyflippingoutthe
L-shapedhandleontheBeltLifter
o
20.UseittoturntheBeltLifterallthewaytotheleft
(counter-clockwise).
1. You may also purchase Odorific
®
II, an odorizer that leaves your room smelling clean and
fresh.PlaceafewdropsonacottonballandtossitintheOuterPermanentBag.Foralist
of other fine Kirby
®
products, see page 56 and 57.
Operating/MaintenanceTips
Operating/MaintenanceTips
Questions and Answers/Troubleshooting