Use and Care Manual

for those who appreciate quality, reliability & performance

Operating/MaintenanceTips

CHANGINGTHEPOWERNOZZLEBELT(cont)

MakesuretheBrushRollBristleHeightAdjustment

setting (1, 2, or 3) is the same as when the brush was

removed.Seepage48fordiscussionoftheBrushRoll

BristleHeightAdjustment(1,2,or3).Placethebelt

andBrushRollbackintothenozzle.OneoftheplasticBrush

Rollendsislargerthantheother,thustheBrushRollwill

only fit in the nozzle one way.

ThencenterthebeltontheBrush.➤

Replace the Rug Plate

26 by placing it on the front of

the bumper first and then pulling it over the bumper on

rear of Power Nozzle

25 . Secure the Rug Plate using

the two latches that hold it in place. ➤

UsingtheL-shapedhandleontheBeltLifter

20 , turn it

to the left (counter-clockwise) until the red arrows line

up. This will stretch the belt in preparation for return-

ing the nozzle to the Ultimate G.

Now you are ready to re-attach the Power Nozzle and

re-engage the belt (see page 11 for details). ❏

Changing The Power Nozzle Belt