Use and Care Manual

40
The Kirby Company
USINGTHEFLOORBUFFER(cont)
Press the Toe-Touch Control
™
Upper Pedal
o
8 to lower
the brush one notch at a time. Lower the brush as far as
the Toe-Touch Control will allow.
WiththeBufferrunning,movetheUltimate G over the floor
as though you were cleaning a carpet, using slow, steady
strokes.
NOTE: The belt should not be stretched when stored for an
extended period. Make sure the green arrows line up for stor-
age(seepage10fordiscussionoftheBeltLifter).❏
HARDFLOORPAD
Seepage15forset-upanduseoftheHardFloorPad.❏
USINGTHECARPETFLUFFER
Your Kirby
®
FloorBuffercanalsobeusedasaCarpet
Fluffer to reset the nap on a matted-down carpet.
Beforefluffingthecarpet,raisethenozzlealltheway
upbypushingtheToe-TouchControlBottomPedal
o
9
all the way down.
Place the cleaner on the carpet to be fluffed. ➤
Plug in the Power Cord. Disengage the TechDrive
®
Power Assist by pressing on the gray “N” side of the
TechDrivePowerAssistN/DPedal
o
11 .
Holdingontothehandlefirmly,startthecleanerbypressing
the ON switch. ➤
9
1
2
Optional Accessories
Optional Accessories
The Floor Care System-Floor Buffer (continued)/The Floor Care
System-Carpet Fluffer