Use and Care Manual

39
for those who appreciate quality, reliability & performance
CAUTION:
ToavoidlosingcontroloftheBufferwhenbrushisonthefloorsurface,
hold on to the handle before plugging the power cord into the wall outlet
and before turning the power switch ON. To avoid possible damage to
soft tiles or marking of waxed and finished non-carpeted floors,
disengage the TechDrive.
!
FLOORBUFFERSET-UP(cont)
Place the hooks located on the rear of the nozzle over the
AttachingBar
o
24 and push the nozzle up against the
Ultimate G.
Turn the Accessory Lock
o
22 all the way to the right
(clockwise) to lock the nozzle in place. ➤
ToengagethedrivebeltandBufferBrush,usethe
L-shapedhandletoturntheBeltLifterallthewayto
the right (clockwise) until the green arrows line up.
LowertheHeadlightCap
o
21 . ➤
DO NOT USE TechDrive
®
Power Assist with the
FloorBuffer.
Place TechDrive Power Assist in Neutral by stepping
on the gray “N” side (“N” for Neutral) of the TechDrive
PowerAssistN/DPedal
o
11 . ➤
USINGTHEFLOORBUFFER
BecausetheunitmovesforwardwhentheFloorBuffer
Brushtouchesthefloor,makesuretheBufferNozzleis
on its highest setting. Press the Toe-Touch Control
TM
BottomPedal
o
9 allthewaydowntoraisetheBufferNozzle
all the way up.
While holding onto the unit’s handle, turn the Ultimate G
ON. ➤
8
5
6
7
Optional Accessories
Optional Accessories
The Floor Care System-Floor Buffer (continued)