Use and Care Manual

38
The Kirby Company
FLOORBUFFERSET-UP
Your Ultimate G can be used as an effective floor buffer for
wood or tile floors.
TousetheFloorBuffer,youmustfirstinserttheBuffer
BrushintotheFloorBufferNozzle.
NOTE: Use only approved Kirby
®
belts.
CenterthebeltoftheBufferBrushinthemiddlearea
between the tufts of the brush. ➤
TurntheBufferNozzleoverandslidetheendsofthe
Brushintotheslotsateachendofthenozzle.The
BufferBrushwillonlyfitthecorrectway.➤
PushthebeltupagainsttheBrushRollwithyourfinger.➤
While holding the belt in place, use the L-shaped han-
dleontheBeltLiftertoturnitleft(counter-clockwise)
untiltheredarrowslineup.TheBeltLifterhookwill
catch the belt and stretch it upward into the nozzle. ➤
1
2
3
4
Optional Accessories
Optional Accessories
The Floor Care System-Floor Buffer
CAUTION:
To avoid loss of control, do not stand unit on end for polishing. For
Kirby units with TechDrive
®
, the TechDrive must be in the neutral
position during polishing.
!