Use and Care Manual

The Kirby Company

CLEANINGTHECARPETSHAMPOOSYSTEM

(cont)

Turn the Accessory Lock

22 to the left (counter-

clockwise).TheCarpetShampooSystemNozzle/Tray

Assembly will tip forward.

LifttheNozzle/TrayAssemblyofftheUltimate G and carry

it to the sink. ➤

Remove the hose from the tray and rinse. ➤

ByusingtheL-shapedhandle,turntheBeltLifterto

the right (clockwise) until the green arrows line up.

Pull the tray and nozzle apart. Rinse tray. ➤

To clean the brush, push the thumb pads located at each end

of the plastic shield and rotate the shield up and away from

the brush.

Disconnect the shield by gently pulling out the ends of the

trayjustbehindtheBrushRoll.

PushtheBrushRolldownoutofthetraybysimultane-

ously pushing on both ends of the brush with both

thumbs.

Rinse all areas of the shield tray and brush, and remove any

lint from brush tufts.

ShakeexcesswaterfromtheBrushRollbybrushinghand

over the bristles and then drying with a towel. ➤

Optional Accessories

The Carpet Shampoo System (continued)