Use and Care Manual

Optional Accessories
33
for those who appreciate quality, reliability & performance
Optional Accessories
USINGTHECARPETSHAMPOOSYSTEM(cont)
As you move the Ultimate G back and forth, foam will be
released and the brush will work it into the carpet.
NOTE: Suds should be dispensed the full width of the tray
when the Ultimate G is pulled backward. If not, pull back
more slowly or check and clean the Shampoo Tank Filter,
if necessary (see page 35).
After suds have been on the carpet at least five minutes, pick
up the foam by turning the Shampoo Tank to the OFF posi-
tion. With the Ultimate G at its lowest height level, move the
Shampooer over the foam until the foam is picked up. Some
moisture will accumulate in the front of the tray. Once the
carpet is thoroughly dry, vacuum with the Kirby
®
Upright
(see page 13). ❏
CLEANINGTHECARPETSHAMPOOSYSTEM
Push the Toe-Touch Control
™
BottomPedal
o
9 all the
way down to raise the nozzle and tray, then turn the
Ultimate G OFF and unplug it. ➤
Turn the Suds Control Valve fully to the left (counter-
clockwise) to the OFF position .
PulltheSmallFlexibleHosefromtheShampooTank
and the tray. ➤
RaisetheHeadlightHood
o
21 . Release the belt by
turningtheBeltLiftertotheleft(counter-clockwise)
until the red arrows line up. ➤
The Carpet Shampoo System (continued)
3
1
2