Use and Care Manual

for those who appreciate quality, reliability & performance

CARPETSHAMPOOSYSTEMSET-UP(cont)

WhileslidingtheCarpetShampooSystemNozzle/

Tray Assembly toward the Ultimate G and over the

Motor Shaft

23 , connect the hooks on the bottom rear

ofthenozzletotheAttachingBar

24 . ➤

Push the nozzle up against the Ultimate G and turn the

Accessory Lock

22 to the right (clockwise) to lock the

nozzle in place. To engage the belt, use the L-shaped

handleontheBeltLiftertoturnitallthewaytothe

right (clockwise) until the green arrows line up. Then lower

theHeadlightHood

21 . ➤

The Shampoo Tank is removable and should be filled or

emptied at your sink.

NOTE: The Shampoo Tank is removed and re-attached in the

same way as the Mini Em-Tor

(see page 10 for details).

Unscrew the large cup from the top of the Shampoo

Tank and turn the Suds Control Valve fully to the left

(counter-clockwise) to OFF.

HoldingtheShampooTanklevel,fillittothefulllinewith

warm water (not hot).

Using the large cup from the top of the tank, pour three cup-

fuls of Kirby

Carpet Shampoo into the Shampoo Tank. Do

not use more, as over-foaming will result.

NOTE: One tankful of solution will clean about a 10x12 foot

carpet (3x3.5m). Larger carpets will require refilling the

Shampoo Tank.

Replace the large cup into the opening on top of the

Shampoo Tank. ➤

Optional Accessories

The Carpet Shampoo System