Owner manual

TM
ISOBUSM0250
Rev. 4/14 47
In the Speed Input settings screen, the ground speed source can be selected, the planter speed sensor can be calibrated,
the manual ground speed can be set, and speed readouts can be seen for each speed source. Tap on the box next to
"Ground Speed Source" to pull up an options menu and select your ground speed source.
NOTE: If the tractor radar or wheel speeds show a value when stationary, press the ZERO button
beside the speed readout. This will set the zero point of the speed source.
Selecting a Current Ground Speed Source
There are 6 possible selections for the Ground Speed Sources:
• Manual–Usesagroundspeedsourcethatissetbytheuser.
• PlanterGroundSpeed–Aspeedsensorlocatedontheplanterthatisconnectedtothe   
Master Module.
• TractorWheelSpeed–WheelspeedsentbythetractorovertheISOBUS.
• TractorRadarSpeed–RadarspeedsentbythetractorovertheISOBUS.
• GPSSpeed–GPSspeedsentbytheGPSReceiverovertheISOBUS.
• Automatic–Usesthebestpossiblespeedavailablefromoneofthefollowingsources,inthisorder:
1. GPS
2. Radar
3. Wheel
4. Planter
NOTE: Kinze recommends that the speed source be set to automatic under normal operating
circumstances.
NOTE: Not all tractors and GPS receivers broadcast speed over the ISOBUS check with your
equipment manufacturer to see if it is compliant.
SPEED INPUT
Settings