Manual

TM
ISOBUSM0246
Rev. 5/14 29
SETTINGS SCREEN
Tap the settings button to toggle through the settings screens. Options include Population Monitoring, Speed Input,
Pneumatic Down Force, Vacuum, Bulk Fill Pressure, Bulk Fill Scale, Seed Sensor Sensitivity, and MUXBUS. Tap on
each item to view settings and make adjustments.
SPEED INPUT
In the Speed Input settings screen, the ground speed source can be selected, the planter speed sensor can be calibrated,
the manual ground speed can be set, and speed readouts can be seen for each speed source.
Selecting a Current Ground Speed Source
There are 6 possible selections for the Ground Speed Sources:
• Manual–Usesagroundspeedsourcethatissetbytheuser.
• PlanterGroundSpeed–Aspeedsensorlocatedontheplanterthatisconnectedtothe   
PMM via the Muxbus.
• TractorWheelSpeed–WheelspeedsentbytheTractorovertheISOBUS.
• TractorRadarSpeed–RadarspeedsentbytheTractorovertheISOBUS.
• GPSSpeed–GPSspeedsentbytheGPSReceiverovertheISOBUS.
• Automatic–Usesthebestpossiblespeedavailablefromoneofthefollowingsources,inthisorder:
1. GPS
2. Radar
3. Wheel
4. Planter
Note: Kinze recommends that the speed source be set to automatic under normal operating circumstances.
Note: Not all tractors and GPS receivers broadcast speed over the ISOBUS check with your equipment
manufacturer to see if it is compliant.
Prev
1. Speed Input Settings
2. Speed Input Values
MANUAL GROUND SPEED
CURRENT GROUND SPEED SOURCE
50500
PLANTER SENSOR PULSES PER MILE
4.0
MANUAL GROUND SPEED
Planter speed sensor
Tractor wheel speed
Tractor radar speed
GPS speed
Automatic
0.0 mph
0.0 mph
0.0 mph
0.0 mph
0.0 mph
3:00 PM
ON
F
E
J
AUTOSWATH
25
DOWNFORCE
DEPTH
10
Prev
CROP TYPE
CORN
POPULATION
SPEED INPUT TC
SETTING
3:00 PM
ON
F
E
J
AUTOSWATH
25
DOWNFORCE
DEPTH
10
Prev
CROP TYPE
CORN
POPULATION
Prev
Population Monitoring
Speed Input
Pneumatic Down Force
Vacuum
1. Select item below
SETTINGS TC
Settings