User Manual

M0238-01Grain Cart
3-26 5/12
TM
Lubrication and Maintenance
Outer Jam Outer Outer Inner Inner Inner
Spindle Nut Seal Cup Cup Seal Spindle
Bolt Bolt
Spindle
Washer Stepped Outer Endwheel Inner
Nut Bearing Hub Bearing
Outer Jam Outer Outer Inner Inner Inner
Spindle Nut Seal Cup Cup Seal Spindle
Bolt Bolt
Spindle
Washer Stepped Outer Midwheel Inner
Nut Bearing Hub Bearing
TRACK ENDWHEEL/MIDWHEEL BEARING REPLACEMENT
1. Endwheel Procedure:
Remove sidebars on side next to endwheel being serviced.
Remove wheel cap screws and special washers that secure nuts for front half of endwheel segments and remove
segments.
Remove endwheel.
Midwheel Procedure:
Remove sidebars on side next to midwheel being serviced.
Remove endwheel (See endwheel procedure above) nearest midwheel being serviced.
NIOTE: If there is a midwheel between endwheel and midwheel being serviced, it must also be removed.
Drop midwheel to clear track carriage and roll it to closest end of track for removal.
1. Position jack at axle and raise side of machine.
2. Mark position of inside and outside sidebars nearest end wheel being serviced.
3. Loosen four ¾" cap screws and 1¼" spindle bolt on each sidebar.
4. Loosen 1" adjusting bolt on each sidebar.