Manual

180 : Kintrek KBP-1
28 Drifting out this cross pin will allow removal of the
. sear and its spring. Caution: Control the spring.
Again, all parts are still in place here. The sequence
has been shown for repair-disassembly purposes.
30 The other Allen screw is inside the group, at this
. location.For access,the safety detent pin and
safety-lever pin will have to be removed. With the
group removed, drifting out the trigger pin will re-
lease the trigger and trigger rod for removal.
29 The trigger group is retained by two Allen screws,
. one visible here. As with the firing system housing,
the trigger group has steel pins in a polymer hous-
ing, and it should be taken apart only for repair.
31 The combination ejector and bolt guide is retained
. on the underside of the receiver by a hex-nut. The
part is moved inward for removal.