Operation Manual Micro-Flo Kit
The Micro-Flo Kit-132 Kit Contents KIT-132 4 Micro-Flo Ballast, 12VDC..……………….BAL-132 2 Universal Power Supplies………………..PWS-152 w/ IEC power cables, USA & Euro 2 Splitter Cable……………………………...PWC-M2 4 Accessory Box ( not illustrated )..………KAS-MCA 1 Travel Case………………………………..
XM3-6 PWC-C2 Extension Cable, 6ft DC Car Plug Adapter REF-150-M 150mm Reflector PWC-A2 REF-100-M 100mm Reflector DC Alligator Clip Adapter PWC-X4 Twist-lock to 4 Pin XLR adapter 5050008 Reflector Cap Micro-Flo lamps have a 3ft harness permanently attached to the lamp. The Lamps are safety coated and sealed for water resistance. The lamps cannot operate beyond the 3ft harness length from the ballast due to impedance losses in the cable.
1) Remove loose reflector cap. ( One end is glued in place.) 2) Insert lamp tip into fixed cap at far end of fixture. 3) Insert removable reflector cap into open end of reflector. Warning! To Ensure Proper Operation ALWAYS TURN OFF THE BALLAST BEFORE connecting or disconnecting lamps, harnesses or Head Extension Cables. Ballast Operation The Micro-Flo Ballast operates remote from the fixture. Connect the Mini-Flo lamp harness to the Ballast.
BAL-132 1) Connect the lamp harness to the end of the ballast marked LAMP. Twist the lock ring to lock in place. LAMP switch must be set to off “O”. 2) Connect the power splitter to the power cable of the ballast. Two ballasts can operate from one power splitter cable. The BAL-132 has two power options: A) Use external power supply (PWS-152) to operate on 90-230VAC/12VDC. IEC power cables (USA/Euro) are included. B) Operate on 12VDC.
BAL-132 Input Voltage: 12 VDC Output Frequency: 25 KHz Amperage: 0.3A / 100mm 0.3A / 150mm Lamp switching: on/off Lamps: 1 100mm T1.5 or 1 150mm T1.5 Weight: 0.2lb / 0.1kg Dimensions: 4” x 1” x 1” 10cm x 2.5cmX2.5cm Environmental: Disposal of Old Electrical & Electronic Equipment. This symbol on the product or on its packaging indicates that this product shall not be treated as household waste.
