User Manual

—
8
—
2.1.5 Week mode
Configuration
SMS Command
Set week mode
MODE,3,T1,T2#
For example
MODE,3,246,09:00# indicates
wake up at 9:00am at Tuesday,
Thursday and Saturday
T1=1:Monday, T1=137
indicates Monday,
Wednesday and Sunday
T2 indicates wake up point ,
format is HH:MM
Note:
Clock mode can’t be wake up by vibration
2.1.6 Motion and static mode
Configuration
SMS Command
Set motion and static mode
MODE,6,T1,T2,A# or MS, T1,T2[,A]#
For example:
MODE,6,60,300,1# Indicates
upload interval in motion status is
60 minutes, upload interval in
static status is 300 minutes, motion
alarm on
T1:Upload interval in
motion status , value 5-43200
minutes
T2: Upload interval in static
status, value 5-43200
minutes or set clock mode,
format (HH:MM)
A:Motion Alarm on, 0:Motion
Alarm off
Note:
Device can’t be wake up by vibration while in motion mode
Device can be wake up by vibration while in static mode
After wake up, there should be 3 seconds vibration in 6 seconds, device will turn on cellular
module and upload position data, otherwise it would enter into sleep mode again and maintain
the previous configuration parameters
2.2 AGPS
When the device successfully registers on network, AGPS is available to speed up the position speed
and improve the position accuracy
2.3 LBS
If device enters into the blind zone and GPS cannot be fixed, the device will switch to LBS position,
LBS provides the reference location which might not be accurate