User's Manual

To prevent fire or shock hazard, do not expose this device to rain or moisture.
Does not use near a bathtub, washbowl, kitchen sink, or laundry tub,
in a wet basement, or near a swimming pool.
►To avoid electrical shock, do not open this device.
►This device should be operated to use only the power supply included with it
or provided as an accessory.
►Do not overload wall outlets and extension cords as this can result in the risk
of fire or electrical shock.
►Do not attempt to service this device yourself. Refer servicing to qualified personnel
only.Reorient or relocate the receiving antenna.
►Increase the separation between the equipment and receiver.
►Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
►Consult the dealer or an experienced radio/TV technician for help.
■ Note:
This equipment has been tested and found to comply with Part 15 of the FCC Rules,
or R&TTE CE directive. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, if not installed and used in accordance
with the instruction, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Important-Safety Precautions
N otice: The chang e or modifications not expressly approved by the party
responsible for compliance could void the us er's authority to operate
the equipment.
IMPORTAN T NOTE: To comply with the FCC RF exposure compliance requi rements,
no change to the antenna or the device is permitted. Any
change to the antenna or the device could res ult in the
device exceedin g the RF exp osure requirement and void
user's authorit y to operate the device.
-1-