User's Manual

I
I
I
.
.
.
U
U
U
s
s
s
e
e
e
N
N
N
o
o
o
t
t
t
i
i
i
c
c
c
s
s
s
1. Be sure the transmitter and the receiver were connected to the equipment correctly (e.g.
Connect the transmitter to the camera, and the receiver to the TV or DVR).
2. When DC plug is pulled out from transmitter or receiver, it needs to wait for a few
seconds to insert it again.
3. Adjust antenna to decrease interference. (vertical or horizontal)
4. In most situations, one pair has a better distance up to 150 meter(open site). When two pairs or more
are used at the same time, It can automatically jump to different channels. But the distance between
transmitter and transmitter (receiver and receiver), preferably greater than 2 meters far.
5. If there are some reasons cause the devise stop, you can try to turn off the power then on again and
make the devise re-link(re-pairing)
6. It is suggested to have 10 pairs mostly operated in same location, but the pairing can not be at the
same time.
J
J
J
.
.
.
T
T
T
r
r
r
o
o
o
u
u
u
b
b
b
l
l
l
e
e
e
s
s
s
h
h
h
o
o
o
o
o
o
t
t
t
i
i
i
n
n
n
g
g
g
Problems
Possible Solution
No picture or sound
Check all cable connections
Make sure power plugs are pushed all the way in
Check power switches on the remote TV or DVR and Video
source(Camera, Camcorder, etc.)
Check if the POWER LED of the transmitter and receiver is lighting or
not? Their LINK LED should be lit.
If Their LINK LED should not be lit, you must re-pair their codes
following the D. instruction of the manual
Interference: picture or
audio
Adjust receiver and transmitter antenna orientation
Try to place transmitter and receiver in a more close-in location
If using a microwave oven, turn it off.
Remove microwave oven or wireless router from path between
transmitter and receiver