User's Manual

FCC Compliance Statement This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference
that may cause undesired operation.
FCC Changes Warning
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
FCC Labeling While the FCC user ID is placed on the master device circuit board, compliant
labeling shall also be placed on the end product housing exterior.
FCC Antenna usage Antennas are required to be permanently attached or of non-standard
connection method to prevent the end user from altering the installation’s performance. The
installer shall be responsible for ensuring that the proper antenna is employed so that the transmit
power limits are not exceeded. Non-approved antennas should not be used. This device has been
designed to operate with the antennas listed below. Antennas not included in this list are strictly
prohibited for use with this device.
FCC Modular approval configuration control
Control of the end product into which the module will be installed must be maintained such that full
compliance of the end product is always ensured. The modular transmitter must comply with any
specific rule or operating requirements applicable to the transmitter and the manufacturer must
provide adequate instructions along with the module to explain any such requirements. It is the
responsibility of the OEM or module level customer to install the master device in accordance with
the guidelines of this manual. In order to maintain compliance with FCC regulations, the module
installer must adhere to the guidelines listed in the installation section of this manual
