User's Guide

ManualsBrandsKingtronics International Trading ManualsAir purifiersG200 Advanced Air Purifier Remote Control

Troubleshooting

Problem Possible Cause Solution

Unit does not power on

• Battery(ies) or AC adapter not installed

• Battery(ies) installed do not have charge

• Install charged Batteries or connect

to AC adapter

• Replace Batteries with charged ones

or install AC adapter

Battery should be charging

• Battery(ies) is(are) full

• No battery(ies) inserted

• AC adapter not plugged in

• Battery may be at end of life

• Battery may be over temperature limit

• The battery light will not display when

full and attached to AC adapter

• Insert 1 or 2 batteries into either slot

• Plug AC adapter into a working outlet

• Install new Battery and recycle old

• Allow the Battery(ies) to cool before

use

Pressure Light AND Warning Light

are illuminated AND Beeping is

heard

• Core Filter not installed properly

• Core Filter is loaded

• Ensure the Core Filter is fully seated

and latched into the Core

• Remove and discard old Core Filter;

install new Core Filter

Unit powered on AND Fan does not

operate AND Warning Light ashing

• General system error (Warning, Pressure,

Beep)

• Remove all power sources; install

AC adapter to verify operation; add

Battery(ies)

Problem Possible Cause Solution

Remote will not pair

• Error in communications • Remove batteries in Remote;

Pressure Light AND Warning Light

are illuminated AND Beeping is heard

remove all power sources from the

Core; reinstall power to the Core then

batteries into the Remote; perform

pairing sequence again

Flow is reduced but no Pressure

Warning Light

• Core Filter life is very close to zero • Replace the Core Filter

Air exiting the Core has an

unpleasant smell

• Carbon Filter may be depleted • Replace the Carbon Filter

Core will not t into the Main Stand

• Pre Filter may not be seated fully • Press the Pre Filter fully into place

and install the Back Cover

Unit powers on then immediately

powers off

• Battery(ies) may be low • Charge Battery(ies) with the supplied

AC adapter

Filter Life Button ashing AND

Beeping

• Filter Life trip point has been met • Press the Filter Life Button once to

silence; Filter Life Button will be solid

but no Beep