User's Manual

2.2 Registering the “Master” Controller
SMS to the device: *master*123456*+1XXXXXXXXXXXX*, (For instance, master
controller phone number is +1XXXXXXXXXXXX. +1 refers to the country code.
XXXXXXXXXXXX is the cellphone number. Please make sure country code is included,
and digit 0 is not needed before cell phone number)
Device Response: "Notice: Cell Phone # xxxxxxxxxx is set to master controller, the
password is 123456.” (The device has a default password of “123456” to initially program
in your PDA/Phone.
NOTE: The device will ONLY listen and respond to instructions from this number unless
you choose to turn on the multi controller function and open the device to any cell phone
number
2.3 Changing the Password:
SMS: *password*654321* (654321 refers to new password)
You will receive the following text: "Notice: The password change is successful for
+1XXXXXXXXXX. The new password is 654321.”
Note: Changing password command has to be sent from master controller number.
3. Motion Detected Alert
the Master Controller will receive an Call/SMS alert once the device detects vibration
indicating possible motion.
3.1 Set vibration sensitivity
There are 5 levels of the motion sensitivity. 1 being the most sensitive, 5 the least, default
setting is 1.
SMS: *sensitive*1-5*
3.2 Set SMS Alert
There will be a SMS alert send to master number when any motion is detected, after 3
minutes of non-movement. The system default setting is alert off, and can be turned
on by command.
SMS: *smsalert*
To enable motion sms alert function.
SMS: *alertoff*
To turn off motion alert function.
4. Tracking via SMS