User's Manual

Long Range LoRa™ TechnologyTransceiver Module

FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void the user's
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co
with any other antenna or transmitter.
15.105 Information to the user.
(b) For a Class B digital device or peripheral, the instructions furnished the
user shall include the following or similar statement, placed in a pr
location in the text of the manual:
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harm
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try t
interference by one or more of the following measures:
—
Reorient or relocate the receiving antenna.
—
Increase the separation between the equipment and receiver.
—
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC
radiation
his equipment should be installed and
your body.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
This transmitter must not be co-
located or operating in conjunction wi
T
he module should not be installed and operated simultaneously with other radios except additional RF
exposure was evaluated for simultaneously transmission.
The availability of some specific channels and/or operational
and are firmware programmed at the factory to match
The firmware setting is not accessible by the end user.
The final end product must be labelled in a visible area with the following:
“Contains Transmitter Module 2AFK9
KT1276
Long Range LoRa™ TechnologyTransceiver Module
KT1276
2017 KingTing Tech. Corporation
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void the user's
This device complies with Part 15 of the FCC Rules.
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co
-located or operating in conjunction
(b) For a Class B digital device or peripheral, the instructions furnished the
user shall include the following or similar statement, placed in a pr
ominent
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harm
ful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try t
o correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
Consult the dealer or an experienced radio/TV technician for help.
radiation
exposure limits set forth for an uncontrolled
environment.
operated with minimum distance 20cm between the
radiator
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
located or operating in conjunction wi
th any other antenna or transmitter.
he module should not be installed and operated simultaneously with other radios except additional RF
exposure was evaluated for simultaneously transmission.
The availability of some specific channels and/or operational
frequency bands
are country dependent
and are firmware programmed at the factory to match
the intended destination.
The firmware setting is not accessible by the end user.
The final end product must be labelled in a visible area with the following:
KT1276
”
KT1276
environment.
T
radiator
and
uncontrolled environment.
th any other antenna or transmitter.
he module should not be installed and operated simultaneously with other radios except additional RF
are country dependent