User's Manual

Long Range LoRa™ TechnologyTransceiver Module

interference will not occurin a particular in
interference to radio or televisionreception, which can be determined by turning theequipment
off and on, the user is encouraged to try tocorrect the interference by one or more of the
following measures:
• R
eorient or relocate the receiving antenna.
• Increase the separation between the equipmentand receiver.
• Connect the equipment into an outlet on acircuit different from that to which the receiver
isconnected.
• Consult the dealer or an experienced radio/T
Additional information on labeling and user informationrequirements for Part 15 devices can be
found in KDBPublication 784748 available at the FCC Office ofEngineering and Technology (OET)
LaboratoryDivision Knowledge Database (KDB)
https://apps.fcc.gov/oetcf/kdb/index.cfm
• RF EXPOSURE
All transmitters regulated by FCC must comply with RFexposure requirements. KDB 447498
General RFExposure Guidance provides guidance in determiningwh
transmitting facilities,operations or devices comply with limits for humanexposure to Radio
Frequency (RF) fields adopted bythe Federal Communications Commission (FCC).
From the KT1276 FCC Grant: Output power listed isconducted.
module issold to OEM integrators and must be installed by theOEM or OEM integrators. This
transmitter is restrictedfor use with the specific antenna(s) tested in thisapplication for
Certification and must not be co-
located
ortransmitters within a host device, except in accordancewith FCC multi
procedures.
•
APPROVED EXTERNAL ANTENNATYPES
To maintain modular approval in the United States, onlythe antenna typ
shall be used.
It is permissible to use different antenna manufacturerprovided the same antenna type and
antenna gain(equal to or less than) is used.
Testing of the KT1276 module was performed with the
• HELPFUL WEB SITES
Federal Communications Commission (FCC):http://www.fcc.gov
FCC Office of Engineering and Technology (OET)Laboratory Division Knowledge Database
(KDB):https://apps.fcc.gov/oetcf/
kdb/index.cfm
Long Range LoRa™ TechnologyTransceiver Module
KT1276
2017 KingTing Tech. Corporation
interference will not occurin a particular in
stallation. If this equipment doescause harmful
interference to radio or televisionreception, which can be determined by turning theequipment
off and on, the user is encouraged to try tocorrect the interference by one or more of the
eorient or relocate the receiving antenna.
• Increase the separation between the equipmentand receiver.
• Connect the equipment into an outlet on acircuit different from that to which the receiver
• Consult the dealer or an experienced radio/T
Vtechnician for help.
Additional information on labeling and user informationrequirements for Part 15 devices can be
found in KDBPublication 784748 available at the FCC Office ofEngineering and Technology (OET)
LaboratoryDivision Knowledge Database (KDB)
https://apps.fcc.gov/oetcf/kdb/index.cfm
All transmitters regulated by FCC must comply with RFexposure requirements. KDB 447498
General RFExposure Guidance provides guidance in determiningwh
ether proposed or existing
transmitting facilities,operations or devices comply with limits for humanexposure to Radio
Frequency (RF) fields adopted bythe Federal Communications Commission (FCC).
From the KT1276 FCC Grant: Output power listed isconducted.
This grant is valid only when the
module issold to OEM integrators and must be installed by theOEM or OEM integrators. This
transmitter is restrictedfor use with the specific antenna(s) tested in thisapplication for
located
or operating in conjunction with any other antenna
ortransmitters within a host device, except in accordancewith FCC multi
-
transmitter product
APPROVED EXTERNAL ANTENNATYPES
To maintain modular approval in the United States, onlythe antenna typ
es that have been tested
It is permissible to use different antenna manufacturerprovided the same antenna type and
antenna gain(equal to or less than) is used.
Testing of the KT1276 module was performed with the
wire antenna, the length is 82mm
.
Federal Communications Commission (FCC):http://www.fcc.gov
FCC Office of Engineering and Technology (OET)Laboratory Division Knowledge Database
kdb/index.cfm
.
KT1276
stallation. If this equipment doescause harmful
interference to radio or televisionreception, which can be determined by turning theequipment
off and on, the user is encouraged to try tocorrect the interference by one or more of the
• Connect the equipment into an outlet on acircuit different from that to which the receiver
Additional information on labeling and user informationrequirements for Part 15 devices can be
found in KDBPublication 784748 available at the FCC Office ofEngineering and Technology (OET)
All transmitters regulated by FCC must comply with RFexposure requirements. KDB 447498
ether proposed or existing
transmitting facilities,operations or devices comply with limits for humanexposure to Radio
This grant is valid only when the
module issold to OEM integrators and must be installed by theOEM or OEM integrators. This
transmitter is restrictedfor use with the specific antenna(s) tested in thisapplication for
or operating in conjunction with any other antenna
transmitter product
es that have been tested
It is permissible to use different antenna manufacturerprovided the same antenna type and
.
FCC Office of Engineering and Technology (OET)Laboratory Division Knowledge Database