User's Manual

a) LED Strip Remote Controllershould alreadyhave batteries installed and
check to see that the green light indicator appears when pressing any
buttons;
b) The LED StripController has been connected to a power source;
Operation Steps:
a) On the remote control, select the desired linked of lights with the group;
For example: Press the button "8" to categorize the corresponding LED
strip to group 8;
b) Press and hold the "LINK" button more than 8 seconds, until the red LED
blinks, then release the "LINK" button;
c) Hold down the button on the LED Strip Controllermore than 3seconds,
until the green LED lights of the controller start flashes, then release the
button; After completion of the unlinking, both the Remote Controller and
LED Strip Controller's LED light will stop flashing and turn off. the linking
between the Remote Control and LED Strip Controller will be removed.
Precautions:
1. Unlinking must be completed in 4 minutes upon entering the unlinking
mode; After 4 minutes, the device will automatically exit the unlinking
mode and the red light indicator will disappear.
2. Press the "LINK" button to exit unlinking mode.